Audi Q3 Owners & Service Manuals

Audi Q3: Safety precautions

Explanation of warning symbols:

Observe all warnings - there is a risk for injury!

Always follow the instructions in the operating manual.

Electrolyte fluid is highly corrosive. Always wear protective gloves and eye protection.

First aid: if electrolyte fluid enters the eyes, immediately flush with clean water for several minutes. Seek medical attention immediately. Immediately neutralize electrolyte fluid on the skin or clothing using a soap solution and rinse with plenty of water. If electrolyte fluid is accidentally ingested, seek medical attention immediately.

Always wear eye protection.

If electrolyte fluid enters the eyes, immediately flush with clean water for several minutes. Seek medical attention immediately.

Fire, sparks, open flame are prohibited. Avoid creation of sparks and short circuits when handling cables and electrical devices.

Always keep children away from battery electrolyte fluid and the battery.

A highly explosive mixture of gases can form when charging batteries.

WARNING

All work on the batteries must only be performed by an authorized Audi dealer or authorized Audi Service Facility.

  • Gases that escape from these batteries can be poisonous or flammable.
  • The contents of these batteries can be corrosive.

    If any battery contents come into contact with the skin, flush the affected area for at least 15 minutes with clean water. Then wash the affected area with soap. Have the affected area examined by a medical professional.

READ NEXT:

  Charging the 12 volt vehicle battery

Fig. 152 Engine compartment with battery: connections for charger and jump start cable Observe the safety precautions. Requirement: only use chargers with a maximum charging current of 14.8 volts. Th

  Windshield washer system

Fig. 153 Engine compartment: washer fluid reservoir cap Observe the safety precautions. The windshield washer reservoir contains the cleaning solution for the windshield/rear window and the headli

  Service interval display

The service interval display detects when your vehicle is due for service. The service interval display works in two stages: Inspection or oil change reminder: after driving a certain distance, a m

SEE MORE:

  Seat Side Trim on the Tunnel Side, Removing and Installing

Removing   WARNING Follow all safety precautions when working with pyrotechnic components. Refer to → Chapter "Pyrotechnic Components Safety Precautions". Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "dis

  Drive Axle, Removing and Installing, Left Drive Axle with CV Joint, Inserted with Inner Splines

Special tools and workshop equipment required Puller - Driveshaft -T10382- Torque Wrench 1332 40-200Nm -VAG1332- Slide Hammer Set -VW771- Removing - Loosen the drive axle threaded connection on the wheel side. Refer to → Chapter "Drive Axle Threaded Connection, Loosenin

© 2019-2026 Copyright www.auq3.net | 0.013