Audi Q3: RSQ3 Spoiler-Lower Section, Removing and Installing
Removing
- Remove the lower radiator grille. Refer to → Chapter "Radiator Grille, Removing and Installing, Audi RS Q3 through MY 2014".
- Remove the bolt -arrow-.
- Release the catches -1- and remove the spoiler lower section -3- forward from the bumper cover -2-.
Installing
Install in reverse order of removal. Note the following:
The guides -2 and 3- on the spoiler lower section -4- must engage in the bumper cover -1- when pushing in the mounts, as shown in the illustration.
- Install the radiator grille. Refer to → Chapter "Radiator Grille, Removing and Installing, Audi RS Q3 through MY 2014".
Bumper Cover Mount Bracket, Removing and Installing
Removing
- Remove the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".
- Remove the bolt -4-.
- Release the securing tabs -1 and 3- carefully upward, and at the same time turn the bracket -2- clockwise -arrow-.
- Remove the impact member bracket.
Installing
Install in reverse order of removal. Note the following:
- Install the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".
Outside Air Temperature Sensor -G17- Bracket, Removing and Installing
Removing
- Remove the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
- Remove the outside air temperature sensor -1-. Refer to → Heating, Ventilation and Air Conditioning; Rep. Gr.87; Additional Components for Control and Regulation; Outside Air Temperature SensorG17, Removing and Installing.
- Remove the bolt -3- and then remove the bracket -2-.
Installing
Install in reverse order of removal. Note the following:
- Install the Outside air temperature sensor. Refer to → Heating, Ventilation and Air Conditioning; Rep. Gr.87; Additional Components for Control and Regulation; Outside Air Temperature SensorG17 Removing and Installing.
- Install the front bumper cover end plate. Refer to → Chapter "Front Bumper Cover End Plate, Removing and Installing".
READ NEXT:
Overview - Rear Bumper Cover
Overview - Bumper Cover, Audi Q3
1 - Bolt
1.7 Nm
Quantity: 2
2 - Bumper Cover Lower Section
There are different versions. Refer to the Parts Catalog.
Removing and
Rear Bumper Cover, Removing and Installing
Caution
If the vehicle has lane change assistance, the lane
change assistance control module -J769-/-J770- must be
recalibrated. Refer to
→ Electrical Equipment; Rep. Gr.9
Attachments, Removing and Installing
Bumper Cover Side Mount, Removing and Installing
Removing
- Remove the rear bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Remove the bolts -arrows-.SEE MORE:
Front seats
General information
Make sure that:
You can press the pedals down completely
while your legs are slightly bent.
The distance between your upper body and the
steering wheel or instrument panel is at least
10 inches (25 cm).
The distance between your knees and the instrument
panel is at least
Parking Brake
Overview - Parking Brake
1 - Bolt
Tightening specification, refer to item-14-.
2 - Parking Brake Motor
Left Parking Brake Motor -V282-, Right Parking Brake Motor -V283-
Removing and installing, refer to
→ Chapter "Left/Right Parking Brake Motor -V282-/-V2