Audi Q3 Owners & Service Manuals

Audi Q3: Roof Bars/Roof Rails

Body Exterior / Body / Audi Q3 (8U) 2011-2018 Service Manual / Roof Bars/Roof Rails

Overview - Roof Railing

Audi Q3. Overview - Roof Railing

1 - Nut

  • Quantity: 4
  • Install with locking compound. For the correct locking compound, refer to the Parts Catalog.
  • Tightening sequence. Refer to → Fig. "Roof Rail - Tightening Specification and Sequence"

2 - Balancing Element

  • Quantity: 4
  • Removing and installing. Refer to → Chapter "Balancing Element, Removing and Installing".

3 - Seal

  • Quantity: 4
  • Replace if damaged

4 - Adjusting Screw

  • 0.4 Nm
  • Quantity: 4
  • Install with locking compound. For the correct locking compound, refer to the Parts Catalog.

5 - Roof Railing

  • Removing and installing. Refer to → Chapter "Roof Railing, Removing and Installing".

Roof Rail - Tightening Specification and Sequence

- Tighten the nuts to 10 Nm in the sequence -2, 3, 4, 1-.

Audi Q3. A66-10945

Overview - Roof Trim Molding

Audi Q3. Overview - Roof Trim Molding

1 - Expanding Clip

2 - Roof Trim Molding

  • Removing and installing. Refer to → Chapter "Roof Trim Molding, Removing and Installing".

3 - Expanding Clip

  • Quantity: 11

4 - Seal

  • For the side window trim molding
  • Self-adhesive

5 - Side Window Trim Molding

  • Removing and installing. Refer to → Chapter "Trim Molding, Removing and Installing".

6 - Clip

  • Quantity: 3

7 - Blind Rivet

  • Quantity: 3

8 - Blind Rivet

  • Quantity: 3

9 - Clip

  • Quantity: 3

READ NEXT:

  Roof Railing, Removing and Installing

Roof Railing, Removing and Installing   WARNING Follow all Safety Precautions when working with pyrotechnic components. Refer to → Body Interior; Rep. Gr.00; Safety Prec

  Exterior Rearview Mirror

Overview - Exterior Rearview Mirror 1 - Bolt 1 Nm 2 - Mirror Adjusting Unit Removing and installing. Refer to → Chapter "Mirror Adjusting Unit, Removing and

  Wheel Housing Liner

Overview - Front Wheel Housing Liner 1 - Front Wheel Spoiler Removing and installing. Refer to → Chapter "Front Wheel Spoiler, Removing and Installing". 2 - Bolt

SEE MORE:

  Wheels and Tires, General Information

Only install tires with the same manufacturer, construction type and tread on all wheels. Always replace rubber valve when replacing steel wheel or rim. Install tires with DOT identification facing toward outside of wheel. Only applies to left side of vehicle with directional tires. With

  Lane Change Assistance, Calibrating

Special tools and workshop equipment required Calibration Tool -VAS6350- Conditions - The Lane Change Assistance Control Module -J769-/ Lane Change Assistance Control Module 2 -J770- must be calibrated using the Vehicle Diagnostic Tester during the following conditions: Lane

© 2019-2026 Copyright www.auq3.net | 0.0115