Audi Q3: Interior lighting
Front interior lighting
.png)
Fig. 40 Headliner: interior lighting
Interior lighting buttons
- Interior lighting on/off
- Door contact switch on/off.
The interior lighting
is controlled automatically.
Touch-sensitive reading lights
- To turn a reading light on or off, touch the surface
1 briefly.
- To activate the manual dimming function,
touch the surface 1 when the light is switched
off and keep touching it until the desired
brightness is reached.
Rear interior lighting
.png)
Fig. 41 Headliner: reading lights
Reading lights
- To switch the reading lamp on or off, press the
button 1.
- To activate the manual dimming function,
touch the surface while the light is switched off
1 and keep touching it until
the desired
brightness is reached.
Interior lighting
Applies to: vehicles with interior lighting
The ambient lighting turns on when the ignition
is switched on. The ambient lighting is deactivated
when the light function is OFF.
The following settings depend on the vehicle
equipment.
- Applies to MMI: Select on the home screen: VEHICLE
> Light & Visibility > Interior lighting.
Possible settings:
Display brightness
You can set the instrument and display illumination.
The settings depend on the vehicle equipment.
- Applies to MMI: select on the home screen:
SETTINGS > Display & brightness.
Possible settings:
- Cockpit dimming
- MMI
- Audi virtual cockpit
READ NEXT:
Adjusting exterior mirrors
Fig. 42 Driver's door: knob for the exterior mirrors
Turn the knob in the driver's door to the desired
position:
- Deactivates all adjustment
functions.
- Selects the le
Manual dimming rearview mirror
Pull the lever on the bottom of the mirror back.
Automatic dimming rearview mirror
The interior and exterior mirrors dim automatically
when light shines on them, f
Switching the windshield wipers on
Fig. 44 Lever: windshield wipers
Fig. 45 Lever: rear window wiper
Move the lever to the
corresponding position:
0 - Windshield wipers off
1 - Rain sensor/intermi
SEE MORE:
Note
The headrests can be removed with the front seats installed.
Removing
- Move the front seat forward into the lowest position and
tilt backrests approximately 45º.
Note
The release button is located on the outer left of the
driver seat and inner left of the passe
Battery Tester with Printer -VAS5097A-
1 - LED green, "Device in use"
2 - LED red, "Device connected with terminals reversed"
3 - LED red "Battery cannot be tested", the Battery -A- must be
replaced.
4 - Start button
5 - Cold cranking output s