Audi Q3: Instrument cluster
Audi Q3 (F3) 2018-2026 Owner's Manual / Display and operation / Instrument cluster
READ NEXT:
Instrument cluster overview
Fig. 2 Audi virtual cockpit plus overview
Fig. 3 Digital instrument cluster or Audi virtual cockpit overview
Depending on the vehicle equipment, the following
items may appear in the instrument clus
Adjusting the display
Fig. 6 Center display: adjusting the display
Switching the view
Applies to: Audi virtual cockpit
Press the VIEW button to switch between the
default view 1 and the enhanced view 2.
Adjusting the
Tachometer
The tachometer 2 displays the engine
speed in revolutions per minute (RPM). The beginning
of the red zone in the tachometer indicates
the maximum permissible engine speed for
all gears once the engine
SEE MORE:
Checking Pressures for Vehicles with Restrictor and Reservoir (with
Internally Regulated Compressor)
General Information
Note
Connect the A/C service station. Refer to
→ Chapter "A/C Service Station, Connecting".
Observe the test requirements. Refer to
→ Chapter "Pressures, Checking".
- With the ignition switched off, check the pressure in the
refrigerant
Upper Transverse Link, Removing and Installing
Upper Transverse Link, Removing and Installing, FWD Vehicles
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Measure dimension from center of wheel to lower edge of
wheel housing. Refer to
→ Chapter "Wheel Bearing in Curb Weig
© 2019-2026 Copyright www.auq3.net
