Audi Q3: Electrical Equipment General Information
Audi Q3 (8U) 2011-2018 Service Manual / Electrical Equipment General Information
- Battery, Starter, Generator, Cruise Control
- Windshield Wiper/Washer System
- Exterior Lights, Switches
- Interior Lights, Switches
- Wiring
READ NEXT:
Battery
Battery General Information
To guarantee a long service life, the Battery -A- must be
checked, serviced and maintained as described in this manual.
The Battery -A- supplies the power to start the
Test Sequence
Battery, Checking, Vehicles with Battery Monitoring Control Module J367 or
Energy Management Control Module J644 and Data Bus On Board Diagnostic Interface
J533
In certain model series the folSEE MORE:
Belt Fastening Detection
Front Passenger Occupant Detection Sensor -G128-, Removing and Installing
Note
The passenger occupant detection sensor is only installed in
the front passenger seat.
Special tools and workshop equipment
required
Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A-
Only for
Connector Assignments, Ready4Nav 7Q4, Navigation Packet 7T2
Information Electronics Control Module 1 -J794-
1 - Connector AM/FM1 from the Antenna Amplifier -R24- (Radio
Antenna 2 -R93-)
2 - DAB connection from Antenna Amplifier 4 -R113-, Digital
Radio Antenna -R183-
3 - GPS connection from the Roof Antenna -R216-
4
© 2019-2026 Copyright www.auq3.net | 0.0109
