Audi Q3 Owners & Service Manuals

Audi Q3: Exterior Lights, Switches

Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Exterior Lights, Switches

HID Headlamp Usage and Safety Precautions

Never replace bulbs if you are not familiar with the procedures, safety precautions and tools.

  WARNING

Danger to life due to high voltage.

  • For work on the yellow high voltage symbol marked areas HID headlamp must be de-energized.
  • Turn off the ignition and all electrical consumers and remove the ignition key.
  • Do not press the flasher.
  • The gas discharge lamp control module should not be operated without the gas-discharge lamp.
  • Due to the high voltage (over 28000 V when igniting the lamp), the gas-discharge lamp should only be operated inside the headlamp housing.

  WARNING

Risk of injury due to burning, UV rays, blinding and explosion.

  • Due the high temperatures, absorption of UV rays, and the risk of blinding, the gas discharge lamp should only be operated inside the headlamp housing.
  • Do not look into the beam of light. It may interfere with the ability to see for a significant period of time.
  • Gas-discharge lamps are under pressure and can crack when bulbs are replaced.
  • When removing and installing HID bulbs, always wear safety glasses and gloves.

  WARNING

Pollution risk.

  • Gas-discharge bulbs require special disposal. They contain metallic mercury (Hg) and traces of thallium.
  • Do not destroy gas-discharge lamps. Avoid contact with burst glass bulbs.
  • Follow disposal requirements, only dispose of gas-discharge lamps in suitable containers at an authorized collection site.

  Caution

  • Do not touch gas-discharge bulbs with bare hands. The remaining fingerprint would evaporate due to the heat of the operated bulb and condense on the reflector which would impair headlamp luminosity. Use clean cloth gloves to insert the gas-discharge lamp.
  • Only replace faulty HID lamps with the same type of lamp. Bulb identification can be found on bulb socket or glass cone.
  • Connectors must engage correctly when installed and must be checked for proper connection.

READ NEXT:

  Interior Lights, Switches

  Immobilizer

General Information The anti-theft immobilizer system control module can depending on the vehicle be integrated in the following systems: Instrument Cluster Control Module -J285- Comfort Syst

  Trailer Hitch

Trailer Hitch Socket, Removing and Installing - Version 1 Removing - Turn off the ignition and remove the key. - Remove the bolts -arrows-. - Detach the socket from the retaining pl

SEE MORE:

  Rearview camera and peripheral cameras

Introduction Applies to: vehicles with rearview camera/peripheral cameras Fig. 113 Orientation line display when parking Depending on the vehicle equipment, a rearview camera or multiple peripheral cameras may be available. The rearview camera helps you to park or maneuver using the orientation li

  Tail Lamps

Overview - Rear Lid Tail Lamps LED tail lamps have LED bulbs and are integrated in the tail lamps. The LEDs cannot be replaced; the entire tail lamp must be replaced. 1 - Tail Lamp In rear lid Removing and installing. Refer to → Chapter "Rear Lid Tail Lamp, Remo

© 2019-2026 Copyright www.auq3.net | 0.0096