Audi Q3: Air Intake Grille Trim, Removing and Installing
Removing
- Remove the air intake grille. Refer to → Chapter "Air Intake Grille, Removing and Installing, Vehicles through MY 2014".
- Remove the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".
- If equipped, remove the parking aid sensor. Refer to → Electrical Equipment; Rep. Gr.94; Overview - Parking Aid.
- Release the tab -arrows- and remove the trim -1- forward.
Installing
Install in reverse order of removal. Note the following:
- Install the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".
- Install air intake grille. Refer to → Chapter "Air Intake Grille, Removing and Installing, Vehicles through MY 2014".
Air Intake Grille, Removing and Installing, Vehicles through MY 2014
Special tools and workshop equipment required
- Hook Tool -T40207-
Removing
- Place the Hook Tool -T40207- in the opening -1- and pull the lower air intake grille-2- from the bumper cover -arrow-.
Installing
Install in reverse order of removal.
Air Intake Grille, Removing and Installing, Vehicles from MY 2015
Removing
- Remove the front bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing".
- Disconnect the connector -4- from the parking aid sensor.
- Release the retainers -3--arrows-.
- Remove the air intake grille -1- from the bumper cover -2- forward.
Installing
Install in reverse order of removal.
Air Intake Grille, Removing and Installing, Audi RS Q3
Special tools and workshop equipment required
- Removal Wedge -T40233-
Removing
- Push the Removal Wedge -T40233- between the bumper cover -1- and the air intake grille -2-, as shown in the illustration.
- Release the air intake grille -arrow- and remove from the bumper cover.
Installing
Install in reverse order of removal.
READ NEXT:
Side Air Intake Trim, Removing and Installing, Audi RS Q3 through MY 2014
Removing
- Left: remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Right: remove the front wheel housing liner and wheel
spoiler. Refer
RSQ3 Spoiler-Lower Section, Removing and Installing
Removing
- Remove the lower radiator grille. Refer to
→ Chapter "Radiator Grille, Removing and Installing, Audi RS Q3
through MY 2014".
- Remove the bolt -arrow-.
- Release
Overview - Rear Bumper Cover
Overview - Bumper Cover, Audi Q3
1 - Bolt
1.7 Nm
Quantity: 2
2 - Bumper Cover Lower Section
There are different versions. Refer to the Parts Catalog.
Removing andSEE MORE:
Multimedia connections
USB adapter
Fig. 139 Audi Genuine Accessories: USB adapter
You can connect your mobile devices to the MMI
using the USB ports with charging function and a
USB adapter, and charge the battery at the same
time.
You can purchase the USB adapter cable from an
authorized Audi dealer or at specialty stor
Tire pressure monitoring system
General notes
Each tire, including the spare (if provided),
should be checked monthly when cold and inflated
to the inflation pressure recommended by the
vehicle manufacturer on the vehicle placard or
tire inflation pressure label. (If your vehicle has
tires of a different size than the size indica