Audi Q3: Additional Components for Control and Regulation
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Additional Components for Control and Regulation
- Sunlight Photo Sensor -G107-, Removing and Installing
- Air Quality Sensor -G238-, Removing and Installing
- Outside Air Temperature Sensor -G17-, Removing and Installing
- Humidity Sensor -G355-, Removing and Installing
READ NEXT:
Sunlight Photo Sensor -G107-, Removing and Installing
Note
The Sunlight Photo Sensor -G107- is only installed with an
automatic climate control system.
Check the Sunlight Photo Sensor -G107- using the Vehicle
Diagnostic Tester in the "
Air Quality Sensor -G238-, Removing and Installing
Removing
- Remove the plenum chamber cover. Refer to
→ Body Exterior; Rep. Gr.50; Bulkhead; Plenum Chamber Cover,
Removing and Installing.
- Release the securing tab -4
Outside Air Temperature Sensor -G17-, Removing and Installing
Note
Complaints may arise regarding the Air Conditioning (A/C)
system regulation if there is a faulty measured value for the
Outside Air Temperature Sensor -G17-. Refer to Vehicle
DiagSEE MORE:
Display overview
Applies to: vehicles with adaptive cruise assist
Fig. 97 Instrument cluster: display in speedometer
Fig. 98 Instrument cluster: driver assistance display
Indicator lights and messages in the speedometer
1 - 3 inform you about the driving situation
and the settings. In the Driver assistance display
Settings
Wi-Fi
Applies to: vehicles with Wi-Fi hotspot
Depending on the country and the vehicle equipment,
the following functions may be available:
Wi-Fi
When the function is switched on, the MMI's Wi-Fi hotspot is active and Wi-Fi
devices can be connected
to the hotspot.
Wi-Fi hotspot settings
The Wi-Fi c
© 2019-2026 Copyright www.auq3.net | 0.0126
