Audi Q3: Storage areas and compartments
Audi Q3 (F3) 2018-2025 Owner's Manual / Starting and driving / Storage and convenience / Storage areas and compartments
Depending on vehicle equipment, there are a variety of storage areas, compartments, and retainers, such as the glove compartment, for safely storing and securing objects.
WARNING
- To reduce the risk of injury, make sure all storage compartments are always closed while driving.
- Loose objects can be thrown around the vehicle interior during sudden driving or braking maneuvers, which increases the risk of an accident. Store objects securely while driving.
- Only use the storage compartments in the door trim panels to store small objects that will not stick out of the compartment and impair the function of the side airbags.
- Only lightweight clothing should be hung
from the garment hooks in the vehicle. Do
not use clothes hangers to hang clothing.
The pockets of the clothing must not contain any heavy, breakable, or sharp-edged objects. This could impair the effectiveness of the side curtain airbags.
- Make sure your view toward the rear is not blocked, for example by hanging clothing or objects in the vehicle.
Tips
Applies to: vehicles with Wi-Fi: Do not place any metal objects in the storage compartment on the end of the rear center console, because they could impair the Wi-Fi antenna function.
READ NEXT:
Luggage compartment
General information
All pieces of luggage or objects must be securely
fastened in the luggage compartment. Note the
following to maintain good vehicle handling:
Distribute the load evenly in the lug
Folding the outer backrests
Applies to: vehicles with folding backrests
Fig.72 Rear bench seat: loop
The rear seat backrests can be folded forward either
separately or together.
Observe the safety precautions.
If necessary, s
Cargo floor
Fig. 76 Luggage compartment: lowering the cargo floor
Removing and installing the cargo floor
To remove the cargo floor, lift it by the handle 4.
Pull the cargo floor toward the vehicle rear, out
SEE MORE:
Vacuum Sensor -G608-, Removing and Installing
Removing
Audi Q3:
- Open the clamps -arrows- and
remove the air guide pipe -1-.
- Disconnect the connector -2-.
- Remove the vacuum hose -3-.
Audi RS Q3:
- Loosen the hose clamps -arrows-
and move the air guide pipe with the hose connected to the side.
- Dis
Airbag and Belt Tensioner Wires, Repairing
In addition to the general repairs on wiring harnesses, the following methods
and instructions must be observed for repairs on airbag- and seat belt tensioner
wires:
WARNING
The airbag and seat belt tensioner system can fail.
Faulty repairs performed on airbag and seat belt
te
© 2019-2025 Copyright www.auq3.net
