Audi Q3: Speed warning system
Description
Applies to: vehicles with speed warning system
The speed warning system helps the driver to stay below a specified maximum speed. A warning threshold can be set in the MMI for this purpose.
Once the speed slightly exceeds the stored threshold, the speed warning system will alert the driver with an indicator in the instrument cluster and a warning tone. Once the speed drops below the stored maximum speed, the indicator will turn off.
Setting a threshold is recommended if you would like to be reminded when you reach a certain maximum speed. Situations where you may want to do so include driving in a country with a general speed limit or if there is a specified maximum speed for winter tires.
Tips
Regardless of the speed warning system, you should always monitor your speed using the speedometer and make sure you are following the legal speed limit.
Setting the warning threshold
Applies to: vehicles with speed warning system
- Applies to: MMI: Select on the home screen: VEHICLE > Driver assistance > Speed warning.
Messages
Applies to: vehicles with speed warning system
The following messages may appear depending on the vehicle equipment:
.png)
Manually set xx mph (km/h)
warning
threshold exceeded
The stored speed was exceeded.
READ NEXT:
Camera-based traffic sign recognition
Description
Applies to: vehicles with camera-based traffic sign recognition
Fig. 92 Instrument cluster: traffic sign recognition
The traffic sign recognition shows the traffic
signs detected by the f
Traffic light information
Description
Applies to: vehicles with traffic light information
Fig. 93 Instrument cluster: traffic light information display
The traffic light information gives you a speed
recommendation in order tSEE MORE:
Satellite map
Applies to: vehicles with navigation system and satellite map
You can display the navigation map with satellite
images.
Requirement: the MMI must be connected to the
Internet.
Applies to: MMI: Select on the home screen:
NAVIGATION > > Map settings >
Satellite
map1).
The map view is
Lower Transverse Link, Removing and Installing
Lower Transverse Link, Removing and Installing, FWD Vehicles
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Measure dimension from center of wheel to lower edge of
wheel housing. Refer to
→ Chapter "Wheel Bearing in Curb Weig