Audi Q3: Setting the distance
Applies to: vehicles with adaptive cruise assist
.png)
Fig. 102 Operating lever: setting the distance
When approaching a vehicle driving ahead, the adaptive cruise assist brakes to the set speed and then maintains the set distance. If the vehicle driving ahead accelerates, then the adaptive cruise assist will also accelerate up to the speed that you have set.
- Tap the rocker switch to display the distance that is currently set.
- To increase or decrease the distance in increments, tap the switch again toward + or -.
The newly-set distance will be shown briefly, for
example with the .png)
indicator light.
If you adjust the speed, you must also change the time gap to the vehicle driving ahead. The higher the speed, the greater the distance that is needed.
The following distances can be set:
.png)
WARNING
Observe the safety precautions and note the limits of the assist systems, sensors, and cameras.
Tips
- When setting the distance, the driver is responsible for adhering to any applicable legal regulations.
- In the Driver assistance display, a graphic
display is shown instead of the indicator
lights 8
.png)
fig. 98. The
display
matches the functions of the indicator
lights. - Depending on the selected driving program and distance, driving behavior when accelerating may vary from moderate to sporty.
- The distances provided are specified values.
Depending on the driving situation and how the vehicle ahead is driving, the actual distance may be more or less than these target distances.
READ NEXT:
Overriding control
Applies to: vehicles with adaptive cruise assist
Fig. 103 Lever: overriding the control
Requirement: the adaptive cruise assist must be
switched on.
Overriding control
You can completely override the
Driver intervention request
Applies to: vehicles with adaptive cruise assist
Fig. 105 Instrument cluster: request for driver intervention
The request for driver intervention instructs you
to resume manual control of the vehicle
Distance warning
Description
Applies to: vehicles with distance warning
Fig. 106 Instrument cluster: display of the current distance
Fig. 107 Instrument cluster: distance warning
General information
At speeds above SEE MORE:
Dimming the mirrors
Manual dimming rearview mirror
Pull the lever on the bottom of the mirror back.
Automatic dimming rearview mirror
The interior and exterior mirrors dim automatically
when light shines on them, for example
from headlights on a vehicle behind you.
WARNING
Applies to: vehicles with automatic di
Brake Master Cylinder, Removing and Installing
Special tools and workshop equipment
required
Brake Charger/Bleeder Unit -VAS5234-
Sealing plugs from Repair Kit -1H0 698 311 A-
Removing
- Remove the brake fluid reservoir, refer to
→ Chapter "Brake Fluid Reservoir, Removing and Installing".
- Disconnect the