Audi Q3 Owners & Service Manuals

Audi Q3: Securing unused safety belts on the rear bench seat

Starting and driving / Audi Q3 (F3) 2018-2026 Owner's Manual / Securing unused safety belts on the rear bench seat

Sitting correctly and safely
Fig. 68 Rear bench seat: securing unused safety belts

If a child safety seat is used on the rear bench seat, the child must not be able to reach any safety belts that are not being used. Secure safety belts that are within reach of the child.

  • If you secure a child safety seat to the LATCH anchors, fasten the safety belt on the seat where the child safety seat is installed using the seat's safety belt latch.
  • If you secure a child safety seat to one of the outer seats, fasten the safety belt for the center seat in its latch.
  • Activate the belt retractor lock on the fastened safety belts. To do this, pull the upper belt out completely and then allow it to retract. You will hear a clicking sound while the belt is retracting.

    It will not be possible to pull the safety belt out any farther.

  • Make sure the fastened safety belt does not block access to the LATCH anchors. Otherwise, it may not be possible to secure the child safety seat to the LATCH anchors correctly.

WARNING

A child in a child safety seat could play with the unused safety belts and then become entangled in them, which increases the risk of fatal injury. Always secure unused safety belts so that they are not within reach of children in child safety seats.

READ NEXT:

  Storage and convenience

  Power sources

When the ignition is switched on, you may be able to use multiple power sources for external devices, depending on the vehicle equipment. 12 volt sockets You can connect electrical accessories to the

  Cup holders

Applies to: vehicles with cup holders Fig. 69 Front center console: cup holders Fig. 70 Rear center armrest: cup holders Cup holders in the front center console Set your beverage in the holder 1.

SEE MORE:

  Tires with Emergency Running Characteristics, Repairing

General Information   Caution Examining damaged tires should only be performed by trained personnel.   WARNING Run-flat tires must be replaced after they have gone flat. Pay close attention to the installation instructions. - The wheel must be inspected before

  Ground Cable with Battery Monitoring Control Module -J367-, Removing and Installing

Ground Cable with Battery Monitoring Control Module -J367-, Removing and Installing, Engine Compartment Battery Version 1 Removing - Turn off the ignition. - Vehicles with ignition lock: Remove the key. - Push the release button -1- and pivot the battery cover -2- upwards at

© 2019-2026 Copyright www.auq3.net | 0.009