Audi Q3 Owners & Service Manuals

Audi Q3: Cup holders

Starting and driving / Audi Q3 (F3) 2018-2026 Owner's Manual / Cup holders

Applies to: vehicles with cup holders

Storage and convenience
Fig. 69 Front center console: cup holders

Storage and convenience
Fig. 70 Rear center armrest: cup holders

Cup holders in the front center console

  • Set your beverage in the holder 1.

Cup holders in the rear center armrest

  • Fold the center armrest downward.
  • To open the cup holder, tap on the button 2.
  • To close the cup holder, fold the cover back until it clicks into place.

WARNING

  • Do not put any hot beverages in the cup holder while the vehicle is moving. Hot beverages could spill, which increases the risk of injury.
  • Do not use any breakable beverage containers (for example, made out of glass or porcelain).

    You could be injured by them in the event of an accident.

Note

Beverage containers in the cup holders should always have a lid. Otherwise, the liquid inside could spill and cause damage to vehicle equipment.

READ NEXT:

  Storage areas and compartments

Depending on vehicle equipment, there are a variety of storage areas, compartments, and retainers, such as the glove compartment, for safely storing and securing objects. WARNING To reduce the risk

  Luggage compartment

General information All pieces of luggage or objects must be securely fastened in the luggage compartment. Note the following to maintain good vehicle handling: Distribute the load evenly in the lug

  Folding the outer backrests

Applies to: vehicles with folding backrests Fig.72 Rear bench seat: loop The rear seat backrests can be folded forward either separately or together. Observe the safety precautions. If necessary, s

SEE MORE:

  Center Console, Removing and Installing

Center Console, Removing and Installing Removing - Remove the center console insert. Refer to → Chapter "Center Console Insert, Removing and Installing". - Versions with Access/Start Authorization Button -E408-: Remove the front storage compartment. Refer to → Chapter

  Glove Compartment Lamp -W6-, Removing and Installing

Removing - Turn the light switch to position "0". - Press in the tab -1- using a flat-head screwdriver and pry out the glove compartment lamp -2-. - Disconnect the connector -3-. Installing Install in reverse order of removal. Note the following: - Connect the connectors

© 2019-2026 Copyright www.auq3.net | 0.0164