Audi Q3: Refrigerant Circuit
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Refrigerant Circuit
- System Overview - Refrigerant Circuit
- Overview - Condenser
- High Pressure Sensor -G65-, Removing and Installing
- Expansion Valve, Removing and Installing
- Receiver/Dryer, Removing and Installing
- Dryer Bag/Dryer Cartridge, Removing and Installing
- Service Connection on Low and High Pressure Side, Removing and Installing
READ NEXT:
System Overview - Refrigerant Circuit
HD = High-pressure end
ND = Low-pressure end
1 - A/C Compressor Regulator Valve -N280-
To check, refer to Vehicle Diagnostic Tester in the "Guided Fault
Finding" function,
→&nb
Overview - Condenser
Overview - Condenser, Dryer Cartridge
Note
There are different versions of the condenser, radiator and
auxiliary radiator. Observe the correct allocation of these components.
Refer t
High Pressure Sensor -G65-, Removing and Installing
Note
When the High Pressure Sensor -G65- is removed, the cooling
output cannot be checked. The Climatronic Control Module
-J255-/A/C Control Module -J301- control head does not switchSEE MORE:
Using adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
Fig. 99 Lever: using adaptive cruise
assist
Fig. 100 Operating lever: changing the speed
Switching on
To switch on the adaptive cruise assist, pull the
lever up to position 1 until it engages.
Storing the speed and activating regulation
If you
Component Location Overview - Airbag Crash Sensors
Component Location Overview - Airbag Crash Sensors, USA and Canada
Market-Specific
1 - Passenger Side Front Airbag Crash Sensor -G284-
Component location: on the right of the lock carrier
Removing and installing. Refer to
→ Chapter "Drive/Front Passenger Front Airbag Cr
© 2019-2026 Copyright www.auq3.net | 0.0098
