Audi Q3: Privacy notice
You can find information about responsibility for data protection in the MMI.
Applies to: MMI: Select on the home screen: SETTINGS > General > Legal notes > About Audi connect.
Image recording
Surrounding area monitoring
Applies to: vehicles with surrounding area monitoring
Some vehicle functions require the vehicle's path to be detected and evaluated. This is done by cameras installed permanently on the vehicle that detect objects in the vehicle's surroundings (such as obstacles or guard rails). The live images from the cameras are transmitted to the applicable control module.
The camera images are transferred to the responsible control module for processing and may be stored, depending on vehicle equipment. The control module analyzes the current camera image using image evaluation software. This image evaluation software detects anonymized technical measurements, such as distances to objects.
The control module evaluates these technical measurements and makes it possible for the assist systems to control the vehicle as needed.
READ NEXT:
Data memories
Vehicle control modules
Fig. 175 Driver's side footwell: connection port for the On
Board Diagnostic System (BD)
Your vehicle is equipped with electronic control
modules fou various vehicle systems s
Transmitted information
Data collection
Applies to: vehicles with data collection
Depending on the country, Audi may collect data
for the following purposes, for example: offer
and product optimization, public safety, provis
Technical data
Identification data
Vehicle data label
Fig. 176 Vehicle identification label
The vehicle identification label
fig. 176 is located
in the luggage compartment under the cargo
floor cover.
The sticke
SEE MORE:
Side Air Intake Trim, Removing and Installing, Audi RS Q3 through MY 2014
Removing
- Left: remove the front bumper cover. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
- Right: remove the front wheel housing liner and wheel
spoiler. Refer to
→ Chapter "Front Wheel Housing Liner, Removing and Installing".
- Carefully remov
Door Inner Cover, Removing and Installing
Special tools and workshop equipment
required
Wedge Set -T10383-
Removing
- Remove the door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Front Door Panels; Front Door
Panel, Removing and Installing.
- Free up the wiring harness -1-.
- Lift the inn
