Audi Q3: Parking Aid Control Module -J446-, Removing and Installing
Note
On vehicles with parallel parking assist the Parallel Parking Assistance Control Module -J791- is integrated in the Parking Aid Control Module -J446-.
- If replacing the control module, select the "Replace Control Module" function Vehicle Diagnostic Tester.
Removing
- Remove the luggage compartment right side trim panel cover.
- Remove the vehicle tools.
- Remove the nuts -1 and 3-.
- Remove the tool kit mount -2-.
- Remove the nuts -arrows-.
- Remove the control module -4-.
- Disconnect the connectors -1, 2 and 3-.
Installing
Install in reverse order of removal.
Front Parking Aid Warning Buzzer -H22-, Removing and Installing
Removing
- Remove the driver side instrument panel cover. Refer to → Body Interior; Rep. Gr.68; Storage Compartments/Covers; Driver Side Instrument Panel Cover, Removing and Installing.
- Remove the instrument cluster. Refer to → Chapter "Instrument Cluster with Instrument Cluster Control Module -J285-, Removing and Installing".
- To reach the upper nut -2- from the mount for the control modules, relay and fuse panel, drill an oblong hole into the instrument cluster mount -1- as shown.
- Dimension -a- = 22 mm.
- Dimension -b- = 23 mm.
Note
Illustrated without the instrument panel.
- Remove the nuts -1 and 3-.
- Disconnect the connector from the buzzer.
- Disengage the mount -2- for the control module, relay and fuse panel from the instrument panel central tube.
- Remove the bolts -1 and 3-.
- Remove the buzzer -2- with expanding clip from the mount -4-.
Installing
Install in reverse order of removal. Note the following:
- Install the instrument cluster. Refer to → Chapter "Instrument Cluster with Instrument Cluster Control Module -J285-, Removing and Installing".
- Install the mount for the control module, relay and fuse panel. Refer to → Chapter "Relay/Fuse Carrier Mount with Vehicle Electrical System Control Module -J519-, Removing and Installing".
Rear Parking Aid Warning Buzzer -H15-, Removing and Installing
Removing
- Remove the cover for the right rear seat belt guide. Refer to → Body Interior; Rep. Gr.70; Passenger Compartment Trim; Overview - C-Pillar Trim Panel.
- Release the retainer -4- upward.
- Remove the rear parking aid warning buzzer -3- from the mount inside the seat belt guide -2-.
- Disconnect the connector -1-.
Installing
Install in reverse order of removal.
READ NEXT:
Front Parking Aid Sensor, Removing and Installing
Front Parking Aid Sensors, Removing and Installing, through MY 2014
Right/Left Front Parking Aid Sensor -G252-/-G255-
Special tools and workshop equipment
required
Hook Tool -T40207-
Removi
Parallel Parking Assist
Overview - Parallel Parking Assist
1 - Parallel Parking Assistance Button -E581-
Overview. Refer to
→ Chapter "Component Location Overview - Instrument Panel Controls".
2&
Automatic Headlamp Range Control
Overview - Automatic Head Lamp Range Control
1 - Left Front Level Control System Sensor -G78-
Component location: on the left front control arm
Removing and installing. Refer to
âSEE MORE:
Additional safety belt functions
Belt retractor lock
The safety belts on the rear seats and on the
front passenger seat are equipped with a belt retractor
lock.
If you secure a child safety seat with a safety
belt, the belt retractor lock on the safety belt
may need to be activated. Follow the instructions
from the child safet
Opening navigation
Applies to: vehicles with navigation system
Fig. 128 Route guidance not started
The navigation system directs you to your destination,
around traffic incidents, and on alternative
routes, if desired.
Opening navigation
Applies to: MMI: Press NAVIGATION on the
home screen.
After accessing the na