Audi Q3: Navigation System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Navigation System
- Overview - Navigation System
- Chip Card Reader Control Module, Removing and Installing
- Connector Assignments, Ready4Nav 7Q4, Navigation Packet 7T2
READ NEXT:
Overview - Navigation System
Overview - Navigation System, General Information
The navigation system is available on vehicles with
Ready4Nav (7Q4), Navigation packet (7T2) and MMI navigation plus
(7T6).
The navigation s
Chip Card Reader Control Module, Removing and Installing
The Chip Card Reader Control Module -J676--1-
is located inside the glove compartment
-2-.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
-&nb
Connector Assignments, Ready4Nav 7Q4, Navigation Packet 7T2
Information Electronics Control Module 1 -J794-
1 - Connector AM/FM1 from the Antenna Amplifier -R24- (Radio
Antenna 2 -R93-)
2 - DAB connection from Antenna Amplifier 4 -R113-SEE MORE:
Interrupting the park assist
Applies to: vehicles with park assist
Park assist will be canceled automatically in the
following scenario:
You switch the system off.
You start steering.
The speed is too high.
The time limit is exceeded.
An obstacle is detected.
ESC intervenes.
Resume control of the vehicle, end the park a
Introduction
The purpose of this repair manual is to provide service
advisors and technicians with the basic knowledge needed to
ensure professional and competent procedures.
Note
Only the careful study of this documentation, practical
implementation of the information contained, training on A/C
© 2019-2026 Copyright www.auq3.net | 0.01
