Audi Q3 Owners & Service Manuals

Audi Q3: General, Technical data

Safety Precautions

Safety Precautions when Working on Start/Stop System

Pay Attention to the Following when Working On Vehicles with a Start/Stop System:

  WARNING

Danger of personal injury when the engine starts automatically.

  • When the Start/Stop System is activated (recognizable by a message in the instrument cluster), the engine can start up automatically if necessary.
  • Make sure the Start/Stop System is deactivated whenever working on the vehicle (switch off ignition; switch it on again if needed).

Safety Precautions during Road Test with Testing Equipment

Pay Attention to the Following if it is Necessary to Use Testing Equipment During A Road Test:

  WARNING

Distraction and improperly secured testing equipment poses an accident risk.

There is a risk due to the front passenger airbag deploying in an accident.

  • Operating testing equipment while driving creates a distraction.
  • There is an increased risk of personal injury if testing equipment is not secured.

Always secure testing equipment with a strap on the rear seat and have a second person on the rear seat operate it.

    READ NEXT:

     Infotainment System

     Overview - Infotainment System

    MMI Navigation Plus, 7T6 Information Electronics Control Module 1 -J794- with DVD player/SD card reader/navigation system integrated in the instrument panel Internal hard drive memory (HDD)

     Infotainment System Display, Removing and Installing

    Infotainment System Display, Removing and Installing The Front Information Display Control Head -J685- (Display) is located in the center of the instrument panel. The display and display support a

    SEE MORE:

     Emissions control system

    General information WARNING The temperature of the exhaust system is high, both when driving and after stopping the engine. Never touch the exhaust tail pipes once they have become hot. This could result in burns. Do not park your vehicle over flammable materials such as grass or leaves because

     Fiber-Optic Cables, Repairing

      Caution Do not bend the fiber-optic cable too much. The bending radius must be no less than 25 mm. Fiber optic cables must not be routed over sharp edges. The fiber-optic cable must not be dirty or touched with bare fingers. Fiber optic cables may not be heated. It is not permit

    © 2019-2026 Copyright www.auq3.net