Audi Q3: Infotainment System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Infotainment System
- Overview - Infotainment System
- Infotainment System Display, Removing and Installing
- Connector Assignments, MMI Navigation Plus
READ NEXT:
Overview - Infotainment System
MMI Navigation Plus, 7T6
Information Electronics Control Module 1 -J794- with DVD
player/SD card reader/navigation system integrated in the
instrument panel
Internal hard drive memory (HDD)
Infotainment System Display, Removing and Installing
Infotainment System Display, Removing and Installing
The Front Information Display Control Head -J685- (Display)
is located in the center of the instrument panel.
The display and display support a
Connector Assignments, MMI Navigation Plus
Information Electronics Control Module 1 -J794-
1 - GSM connection from Roof Antenna -R216-
2 - 4-Pin Connector -T4u- to the External Audio Source
Connection -R199-SEE MORE:
Tire pressure
Fig. 156 Driver's side B-pillar: tire pressure
label
Fig. 157 Tire pressure label
The correct tire pressure for tires
installed at the factory is listed on
a label. The label is located on the
B-pillar (driver's side) fig. 156,
fig. 157.
Use the tire pressure specified for
a normal vehicle load
Driver Side Instrument Panel Cover, Removing and Installing
Note
As a replacement part, the new cover is delivered with an
additional attaching point.
Special tools and workshop equipment
required
Wedge Set -T10383-
Removing
- Remove the side cover from the instrument panel on the
driver side. Refer to
→ Chapter "Instru
© 2019-2026 Copyright www.auq3.net | 0.0098
