Audi Q3 Owners & Service Manuals

Audi Q3: General information

  • Park the vehicle as far as possible from moving traffic in the event of a breakdown. In the event of a flat tire, park the vehicle on a level surface.

    If you are on a steep hill, be especially careful.

  • Set the parking brake.
  • Switch the emergency flashers on.
  • Have the passengers exit the vehicle. They should move to a safe place, for example behind a guard rail.

WARNING

Follow the steps given above. This is for your protection and the for the safety of others on the road.

Equipment

Vehicle tool kit/vehicle jack

Applies to: vehicles with the vehicle tool kit and vehicle jack

Emergency assistance
Fig. 158 Luggage compartment: cargo area floor

The vehicle tools and vehicle jack are stored in the luggage compartment under the cargo floor.

  • Lift up the cargo floor with the plastic handle until it is clamped behind the tabs on both side panels.
  • If necessary, lift out the center floor panel

Applies to: vehicles with spare tire/subwoofer

  • Turn the handwheel counter-clockwise and remove it.
  • Remove the subwoofer.
  • Remove the spare tire.

Tips

The vehicle jack does not require any maintenance.

READ NEXT:

  Changing a tire

Preparation You must complete the preparation before changing a tire. Read and follow the important safety precautions. Set the parking brake. Select the "P" position. When towing a trailer: disc

  Spare tire

Removing the subwoofer Applies to: vehicles with subwoofer The subwoofer must be removed before the spare tire/temporary spare tire can be removed. Fig. 166 Spare tire well: subwoofer Removing the su

  Jump starting

Preparation You should only perform the steps that follow if you have the necessary tools and technical expertise. If the engine does not start because the vehicle battery is drained, you can jump sta

SEE MORE:

  Speed warning system

Description Applies to: vehicles with speed warning system The speed warning system helps the driver to stay below a specified maximum speed. A warning threshold can be set in the MMI for this purpose. Once the speed slightly exceeds the stored threshold, the speed warning system will alert the dri

  Foot Rest, Removing and Installing

Special tools and workshop equipment required Trim Removal Wedge -3409- Removing - Remove the front driver side sill panel trim. Refer to → Chapter "Front Sill Panel Strip, Removing and Installing". - Unclip foot rest -1- using the Trim Removal Wedge -3409--arrow- an

© 2019-2026 Copyright www.auq3.net | 0.0091