Audi Q3: Front Heater and A/C Unit
READ NEXT:
Overview - Heater and A/C Unit Attachments and Air Intake Housing
1 - Sealing Plug
Equipment version
2 - Screw
1.5 Nm
3 - Screw
1.5 Nm
4
Removing
- Removing the air distribution housing. Refer to
→ Chapter "Air Distribution Housing, Removing and Installing".
- Remove the spacer foam -6-.
- Remove the bolts -1
Note
An auxiliary heater is currently installed in vehicles with
a TDI engine. After leaving the heater core for the heater/A/C
unit, the air is supplied with heat energy on this syst
SEE MORE:
You can adjust the central locking system to your
preferences. The settings depend on the vehicle
equipment.
Applies to MMI: Select on the home screen: VEHICLE
> Settings & Service > Central locking.
Door unlocking
If you select All, all doors and the luggage compartment
lid will be
Special tools and workshop equipment
required
Locating Pins -T10096-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Procedure
- Remove the noise insulation -1-.
Refer to
→ Body Exterior; Rep. Gr.66; Noise Insulation; Noise Insulation,