Audi Q3: Fastening and unfastening safety belts
Starting and driving / Audi Q3 (F3) 2018-2026 Owner's Manual / Fastening and unfastening safety belts
.png)
Fig. 60 Belt buckle and belt latch
.png)
Fig. 61 Releasing the belt buckle from the belt latch
Fastening the safety belt
- Pull the safety belt by the belt buckle evenly across your chest and lap.
- Insert the belt buckle in the belt latch belonging
to the seat until it audibly engages
.png)
fig. 60. - Pull on the belt to make sure that the belt is securely locked in the latch.
Unfastening the safety belt
- Press the red button on the belt latch
fig. 67.
The belt buckle will pop out.
- Guide the belt back by hand so that the safety belt can roll up more easily.
Safety belt monitoring system
.png)
- if the indicator light turns
on or flashes, a front safety belt is not fastened or it has been un fastened
while driving. There may be additional
audible warning signals.
Adjusting the height of the safety belt
.png)
Fig. 62 Belt height adjustment for the front seats - safety
belt relay
- To move the belt higher, slide the safety belt relay 2 upward.
- To move the belt lower, press the release button 1 and slide the safety belt relay 2 downward.
- To check if the safety belt relay is securely locked in place, pull firmly on the belt.
Tips
You can also adjust the height of the front seats to change the position of the safety belts.
READ NEXT:
Additional safety belt functions
Belt retractor lock
The safety belts on the rear seats and on the
front passenger seat are equipped with a belt retractor
lock.
If you secure a child safety seat with a safety
belt, the belt retrac
Memory function
General information
With the memory function, you can save and call
up seat profiles using the memory buttons in the
door trim panel.
Depending on vehicle equipment, some settings
such as the driver's
Airbag system
General information
WARNING
If you have not fastened your safety belt,
you are in an incorrect seating position, or
you are too close to the airbag system, the
airbag system will not be able to pSEE MORE:
Door Lock, Removing and Installing
Door Lock, Removing and Installing
Caution
There is a risk of malfunctions.
The door lock must be removed and installed together
with the bracket to prevent over-bending the cable when
disengaging and engaging it.
The cable must be disconnected from/attached to the
lever on the d
Luggage Compartment Side Trim Panel, Removing and Installing
Special tools and workshop equipment
required
Pry Lever -80-200-
Omega Clip Tool -T40280-
Removing
- If installed, remove the luggage compartment roller cover.
- Remove the rear seat backrest. Refer to
→ Chapter "Rear Seat Backrest, Removing and Installing".
- V
© 2019-2026 Copyright www.auq3.net | 0.0133
