Audi Q3: Display and Control Head
Audi Q3 (8U) 2011-2018 Service Manual / Heating, Ventilation & Air Conditioning / Air Conditioning / Display and Control Head
READ NEXT:
Overview - Display and Control Head
Overview - Display and Control Head, Manual Climate Control System (Heater
without A/C System)
A/C Control Module -J301- (Heater Control Module -J65-)
Note
The following illustration
Display and Control Head, Removing and Installing
Display and Control Head, Removing and Installing, A/C Control Module
-J301- (Heater Control Module -J65-)
Note
Only for vehicles with a manual climate control system
(heater without
SEE MORE:
Check Valve, Checking
Check valve is removed, refer to
→ Chapter "Check Valve, Removing and Installing".
Note
The check valve is installed directly in front of the vacuum
pump.
Valve must allow air to flow in direction of arrow.
Valve must remain closed in opposite direction.
Installation Instructions, Run-Flat Tires
Warm up cold tires to the minimum mounting temperature
Note
This applies also to ultra high performance tires
(height-/width ration smaller/same 45% and speed rating symbol
larger than/same as V).
WARNING
The minimum mounting temperature for a tire may not
be below 21℃
© 2019-2026 Copyright www.auq3.net
