Audi Q3: Additional Components for Control and Regulation
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Additional Components for Control and Regulation
- Sunlight Photo Sensor -G107-, Removing and Installing
- Air Quality Sensor -G238-, Removing and Installing
- Outside Air Temperature Sensor -G17-, Removing and Installing
- Humidity Sensor -G355-, Removing and Installing
READ NEXT:
Sunlight Photo Sensor -G107-, Removing and Installing
Note
The Sunlight Photo Sensor -G107- is only installed with an
automatic climate control system.
Check the Sunlight Photo Sensor -G107- using the Vehicle
Diagnostic Tester in the "
Air Quality Sensor -G238-, Removing and Installing
Removing
- Remove the plenum chamber cover. Refer to
→ Body Exterior; Rep. Gr.50; Bulkhead; Plenum Chamber Cover,
Removing and Installing.
- Release the securing tab -4
Outside Air Temperature Sensor -G17-, Removing and Installing
Note
Complaints may arise regarding the Air Conditioning (A/C)
system regulation if there is a faulty measured value for the
Outside Air Temperature Sensor -G17-. Refer to Vehicle
DiagSEE MORE:
Lock Carrier
Overview - Lock Carrier
1 - Lock Carrier
Removing and installing. Refer to
→ Chapter "Lock Carrier, Removing and Installing".
2 - Bolt
4.5 Nm
3 - Bolt
4.5 Nm
4 - Lower Mount
For the front bumper cover, and headlamp housing
Wheels and Tires, General Information
Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification facing toward outside
of wheel. Only applies to left side of vehicle with directional
tires.
With
© 2019-2026 Copyright www.auq3.net | 0.009
