Audi Q3 Owners & Service Manuals

Audi Q3: Cargo floor

Storage and convenience
Fig. 76 Luggage compartment: lowering the cargo floor

Removing and installing the cargo floor

  • To remove the cargo floor, lift it by the handle 4.
  • Pull the cargo floor toward the vehicle rear, out of the luggage compartment.
  • To insert the cargo floor, push it all the way toward the backrest.

Lowering/raising the cargo floor

Applies to: vehicles with adjustable cargo floor

The height of the cargo floor can be adjusted to.

create more space in the luggage compartment or to make loading and unloading easier.

  • To lower the cargo floor, lift it at the handle 4.
  • Pull the cargo floor slightly back and then push it forward again to position 2 or 3.
  • To raise the cargo floor, remove it and reinsert it in position 1.

Audi recommends moving the cargo floor back into position 1 after transporting goods.

Depending on vehicle equipment, there may be a middle floor panel under the adjustable cargo floor. Remove the middle floor panel to reach the vehicle tool kit located below.

    READ NEXT:

     Roof rack

    General information Applies to: vehicles with roof rack mount Fig. 77 Roof rail: mounting points If luggage or cargo is to be carried on the roof, you must observe the following: These roof racks a

     Warm and cold

     Climate control system

    Description One of the following options may be available, depending on vehicle equipment: A deluxe automatic climate control system with two zones to individually adjust temperature and air distri

    SEE MORE:

     Overview - Rear Brakes

    Overview - Rear Brakes, Brakes 1KU 1 - Brake Shield Removing and installing, refer to → Chapter "Brake Shield, Removing and Installing, Brakes 1KU". 2 - Brake Rotor Allocation, refer to the Parts Catalog. Dimensions → Chapter "Brakes Technical Da

     A/C Compressor Regulator Valve -N280-, Checking Switch-On Signal

    Special tools and workshop equipment required Vehicle Diagnostic Tester Connector Test Set -VAG1594D- Probe -VAS5051/8- Test Sequence - Remove the noise insulation. Refer to → Body Exterior; Rep. Gr.66; Noise Insulation; Noise Insulation, Removing and Installi

    © 2019-2025 Copyright www.auq3.net