Audi Q3: Body Front
READ NEXT:
Lock Carrier
Overview - Lock Carrier
1 - Lock Carrier
Removing and installing. Refer to
→ Chapter "Lock Carrier, Removing and Installing".
2 - Bolt
4.5 Nm
3 -&nbs
Fender
Overview - Fender
1 - Bolt
8 Nm
Quantity: 2
2 - Lower bracket
For the fender
Removing and installing. Refer to
→ Chapter "Fender, Removing and Installing
Bulkhead
Overview - Bulkhead
1 - Gasket for Plenum Chamber
To remove, pull forward off the body flange.
Mount the seal on the foam piece -arrows-
and then push it onto the flange on the bo
SEE MORE:
0.22 mm 2 Wire, Repairing with Individual
Crimp Connector
Procedure
- Free up the wire to be repaired approximately 20 cm on both
sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harnesses carefully.
- If necessary, removing the wiring harness wrapping using a
knife.
- Cut ou
General, Technical data
Repair Information
Wire Routing and Securing
When loosening or removing and installing hydraulic, pneumatic or electrical
lines, draw sketches or take pictures. This will ensure they are installed in
their original positions.
Contact Corrosion
Contact corrosion can occur if incorrect fastene
© 2019-2026 Copyright www.auq3.net
