Audi Q3: Antilock Brake System
Chassis / Audi Q3 (8U) 2011-2018 Service Manual / Antilock Brake System
READ NEXT:
General Information
ABS Repair Instructions
ABS malfunctions do not affect the brake system and the
booster. Conventional brake system stays operative even without
ABS. A change in braking behavior should be checked
Control Module and Hydraulic Unit
Overview - Control Module and Hydraulic Unit
1 - Brake Booster
Removing and installing, refer to
→ Chapter "Brake Booster, Removing and Installing".
2 - Brake Li
Sensors
Overview - Front Axle Speed Sensor
1 - Wheel Speed Sensor
Right Front ABS Wheel Speed Sensor -G45-/Left Front ABS Wheel Speed
Sensor -G47-
Removing and installing, refer to
→&SEE MORE:
Seat Angle Adjuster, Removing and Installing
Seat Angle Adjustment Handle, Removing and Installing
Note
Removal and Installation can be done with the seat
installed.
Removing
- Remove the seat side sill panel trim. Refer to
→ Chapter "Seat Side Trim on Sill Panel Side, Removing and
Installing, Manual Front Seat".
Additional Wheel Housing Enlargement, FLAPS
On some vehicles with certain wheel/tire combinations, wheel
housing enlargements (FLAPS) must be attached on the fenders or
bumper for technical reasons -arrows-.
Please check whether FLAPS must be installed.
The necessary wheel/tire combination information can be
found in the overview tabl
© 2019-2026 Copyright www.auq3.net | 0.0115
