Audi Q3: Additional settings
Audi Q3 (F3) 2018-2026 Owner's Manual / Additional settings
READ NEXT:
System settings
Introduction
General settings are described in this chapter.
You can find specific settings in the chapters
about those settings. The available settings depend
on the vehicle equipment.
Date and time
Connected devices
Displayed connected devices
Requirement: the vehicle must be stationary and
the ignition must be switched on.
Applies to: MMI: Select on the home screen:
SETTINGS > Connected devices.
Possible
Legal information
General information
Information on the software licenses can be
found online at www.audi.com/softwareinfo.
Multi Media Interface
Applies to: MMI: Select on the home screen:
SETTINGS > General.
SEE MORE:
Glove Compartment Lamp -W6-, Removing and Installing
Removing
- Turn the light switch to position "0".
- Press in the tab -1- using a
flat-head screwdriver and pry out the glove compartment lamp
-2-.
- Disconnect the connector -3-.
Installing
Install in reverse order of removal. Note the following:
- Connect the connectors
Laws and Regulations
General Information
Note
The laws and regulations listed below are applicable in
Germany. Different or additional laws and regulations may apply
in other countries.
The effects of climate change can be seen worldwide.
Protecting the climate is one of the most important
responsibi
© 2019-2026 Copyright www.auq3.net | 0.0095
