Audi Q3 Owners & Service Manuals

Audi Q3: Turn signal and high beam lever

Lights and Vision
Fig. 38 Operating lever: switching the light functions on and off

The lever operates the turn signals, the high beams and the headlight flasher.

Turn signals

The turn signal will activate when you move the lever into a turn signal position while the ignition is switched on. The respective or indicator light will flash. The turn signal blinks three times if you tap the lever (convenience turn signal).

  1. Right turn signal
  2. Left turn signal

If an indicator light blinks twice as fast as usual, a turn signal bulb has failed. Carefully drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

High beams and headlight flasher

  • Move the lever to the corresponding position:
  1. High beams on (vehicles with High beam assistant)
  2. High beams off or headlight flasher

The indicator light in the instrument cluster turns on.

WARNING

High beams can cause glare for other drivers, which increases the risk of an accident. For this reason, only use the high beams or the headlight flasher when they will not create glare for other drivers.

    READ NEXT:

     High beam assistant

    Applies to: vehicles with high beam assistant The high beam assistant automatically turns the high beams on or off depending on the surrounding conditions. A camera on the rearview mirror mount can d

     Adjusting the exterior lighting

    The following settings depend on the vehicle equipment. Applies to: MMI: Select on the home screen: VEHICLE > Light & Visibility > Exterior lighting. Automatic headlights You can adjust

     Interior lighting

    Front interior lighting Fig. 40 Headliner: interior lighting Interior lighting buttons - Interior lighting on/off - Door contact switch on/off. The interior lighting is controlled automatically. T

    SEE MORE:

     Clean Working Conditions

    Even slight contamination can lead to defects. Therefore observe the following rules for cleanliness when working on the A/C system: Immediately seal the open lines and connections with clean plugs, for example from the Engine Bung Set -VAS6122-. Place the components that have been remov

     Modular Wiring Routing with Corrugated Tube

    Opening the corrugated tube and removing the individual wire   WARNING Follow all safety precautions when working with pyrotechnic components. Refer to → Chapter "Pyrotechnic Components Safety Precautions". Before handling pyrotechnic components (for example, disconnectin

    © 2019-2025 Copyright www.auq3.net