Audi Q3: Trailer hitch
Introduction
Only use a trailer hitch with a removable ball hitch mount and ball hitch. The trailer hitch must be permitted for the vehicle, the trailer and the permitted total weight of the trailer being pulled. Above all, it must be securely and safely attached to the vehicle trailer.
Never mount a trailer hitch on the bumper. The trailer hitch must be mounted in a way that does not impair the function of the bumper. Do not make any changes to the exhaust system and the brake system.
Check regularly if the trailer hitch is securely mounted. Always follow the instructions given by the trailer hitch manufacturer.
WARNING
Never mount a "weight-distributing" or "load-balancing" trailer coupler as the trailer hitch.
The vehicle was not designed for these types of trailer hitches. The trailer hitch can malfunction and the trailer can separate from the vehicle, which increases the risk of an accident.
Using the trailer hitch
Applies to: vehicles with trailer hitch
.png)
Fig. 87 Rear bumper: trailer hitch
The trailer hitch of your vehicle consists of the receiver 3, the connector1) 1 or connector retainer, two eyelets 2 for the safety chains, and the receiver cover 4.
The receiver 3 is suitable for securing a removable ball hitch mount with a ball head, for example when towing a trailer.
- In order to use the trailer hitch, pull the cover 4 out of the receiver 3 in direction of the arrow.
- Check the receiver 3 for dirt and clean it if necessary.
- When towing a trailer, use the trailer connector1) 1 and secure the safety chains using the eyelets 2.
- To prevent dirt from entering the receiver 3, close it with the cover 4 after using it.
1) In certain countries.
WARNING
- For your own safety, read the installation instructions provided by the ball hitch mount manufacturer.
- There is a risk of an accident if the ball hitch mount is installed incorrectly. The ball hitch mount must be secured in the receiver 3 correctly. The same applies to accessories that are secured in the receiver.
- Only use a ball hitch mount with ball head suitable for your vehicle and your trailer.
- To reduce the risk of injury, always remove the ball hitch mount if no trailer is mounted.
- To reduce the risk of an accident, contaminants on the trailer hitch must be removed because otherwise the ball hitch mount might not be secured correctly in the receiver.
Tips
- No ball hitch mount or ball head is provided with the trailer hitch. You can purchase these at specialty stores.
- The eyelets on the trailer hitch are only intended for securing the trailer safety chains.
READ NEXT:
Driving with a trailer
Trailer brakes
If the trailer has its own brake system, then follow
the manufacturer specifications. However,
the brake system on the trailer must never be
connected to the vehicle brake system.
Safet
General information
Safety precautions
WARNING
As the driver, you are always completely responsible
for all driving tasks. The assist
systems cannot replace the driver's attention.
Give your full attention to drivinSEE MORE:
Traffic light information
Description
Applies to: vehicles with traffic light information
Fig. 93 Instrument cluster: traffic light information display
The traffic light information gives you a speed
recommendation in order to reach the next traffic
light when it is green 1, or it informs you of
the wait time at the next re
Glove Compartment Handle, Removing and Installing
Special tools and workshop equipment
required
Locking Pin (3 pc.) -T40011-
Removing
Note
If glove compartment cover does not open, it can be opened
via the emergency release. Refer to
→ Chapter "Glove Compartment Lid Emergency Release, Operating".
- Press the glo