Audi Q3 Owners & Service Manuals

Audi Q3: Steering wheel heating

Switching on and off

Applies to: vehicles with steering wheel heating

  • Press the button on the multifunction steering wheel to switch the steering wheel heating on and off.

Messages

Applies to: vehicles with steering wheel heating

The following messages may appear depending on the vehicle equipment:

Steering wheel heating: malfunction! See owner's manual

If this message appears, there is a malfunction.

Drive immediately to an authorized Audi dealer or authorized Audi Service Facility to have the malfunction repaired.

Fluids in the A/C system

Refrigerant in the A/C system

The sticker in the engine compartment provides information about the type and amount of refrigerant used in the vehicle's A/C system. The sticker is located in the front section of the engine compartment or at the front or back of the hood.

Warning: the A/C system must only be serviced by qualified technicians.

Refrigerant type

  Lubricant type

Refer to the service information (only available for authorized Audi dealers or authorized Audi Service Facilities)

The A/C system must only be serviced by qualified technicians.

Flammable refrigerant

Make sure all components are disposed of correctly and never install components in the vehicle that have been removed from old vehicles or taken from recycling.

Lubricant in the A/C system

The sticker in the engine compartment provides information about the type and amount of refrigerant oil used in the vehicle's A/C system.

WARNING

To ensure correct and safe operation, the A/C system must only be serviced by qualified and certified technicians (SAE standard J2845 and 32911).

Tips

  • Never repair the A/C system evaporator with components from old vehicles or from recycling.
  • New replacement evaporators for portable A/C systems must be certified and labeled as such, so that they comply with the SAE standard J2842 HFO-1234yf and R744.

    READ NEXT:

     Driving

     Starting the vehicle

    Convenience key Applies to: vehicles with convenience key Fig. 79 Center console: starting the engine Requirement: the key must be in the vehicle. Starting the engine Press and hold the brake pedal

     Ignition key

    Applies to: vehicles with ignition lock Fig. 80 Steering column: ignition lock Starting the engine Press the brake pedal. Insert the ignition key into the ignition lock. Turn the key briefly to p

    SEE MORE:

     Overview - Front Seat

    Overview - Front Seat, Manual Standard Seat/Sport Seat 1 - Seat Angle Adjuster Only for Sport seats Overview. Refer to → Chapter "Overview - Seat Pan, Seat Angle Adjuster". Removing and installing. Refer to → Chapter "Seat Angle Adjuster, Removing and Installin

     Belt Fastening Detection

    Front Passenger Occupant Detection Sensor -G128-, Removing and Installing   Note The passenger occupant detection sensor is only installed in the front passenger seat. Special tools and workshop equipment required Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A- Only for

    © 2019-2024 Copyright www.auq3.net