Audi Q3: Repair Information
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Repair Information
- Clean Working Conditions
- Heating Output, Checking
- Cooling Output, Checking
- Cooling Output, Checking, Manual Climate Control System
- Cooling Output, Checking, Automatic Climate Control System
- Refrigerant Circuit, Discharging
- Actuator Information
READ NEXT:
Clean Working Conditions
Even slight contamination can lead to defects. Therefore
observe the following rules for cleanliness when working on the
A/C system:
Immediately seal the open lines and connections with clean
Heating Output, Checking
Heating Output, Checking
Note
This repair manual only outlines the checking procedure.
Perform the detailed function test for the heating as described
in the Guided Fault Finding using
Cooling Output, Checking
Cooling Output, Checking
Special tools and workshop equipment
required
Vehicle Diagnostic Tester
A standard thermometer (for temperature measurements, if
necessary a thermometer with two meSEE MORE:
Satellite map
Applies to: vehicles with navigation system and satellite map
You can display the navigation map with satellite
images.
Requirement: the MMI must be connected to the
Internet.
Applies to: MMI: Select on the home screen:
NAVIGATION > > Map settings >
Satellite
map1).
The map view is
Sunlight Photo Sensor -G107-, Removing and Installing
Note
The Sunlight Photo Sensor -G107- is only installed with an
automatic climate control system.
Check the Sunlight Photo Sensor -G107- using the Vehicle
Diagnostic Tester in the "Guided Fault Finding" function, A/C
system.
Removing
- Using a 0.4 mm feeler gauge -1-,
© 2019-2026 Copyright www.auq3.net | 0.0112
