Audi Q3: Rearview Camera System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Rearview Camera System
READ NEXT:
Overview - Rearview Camera System
The rear view camera system assists the driver when driving
in reverse by providing the driver with an image of the traffic
situation behind the vehicle via the Front Information Display
Control
Rearview Camera -R189-, Removing and Installing
The Rearview Camera -R189- is inside the rear lid handle
button. It permanently attached to the button.
If the Rearview Camera -R189- must be replaced, then the
handle button must also be replace
Multifunction Steering Wheel
Overview - Multifunction Steering Wheel
Buttons are integrated in the steering wheel for easier
operation of Infotainment, telephone and the navigation system.
On vehicles with Tiptronic, rockSEE MORE:
Opening and closing the hood
The hood is released from inside the vehicle.
Fig. 144 Footwell: release lever
Fig. 145 Unlocked hood: lever
Observe the safety precautions.
Make sure the wiper arms are not raised up from
the windshield. Otherwise the paint could be
damaged.
Opening the hood
With the door open, pull the lever
Inner Door Seal, Removing and Installing
Removing
- Remove the upper A-pillar trim. Refer to
→ Body Interior; Rep. Gr.70; Passenger Compartment Trim;
A-Pillar Trim, Removing and Installing.
- Remove the front sill panel strip. Refer to
→ Body Interior; Rep. Gr.70; Passenger Compartment Trim
© 2019-2026 Copyright www.auq3.net | 0.0091
