Audi Q3 Owners & Service Manuals

Audi Q3: Rear seats

Starting and driving / Audi Q3 (F3) 2018-2026 Owner's Manual / Rear seats

General information

WARNING

  • To reduce the risk of an accident, only adjust the seat when the vehicle is stationary.
  • Be careful when adjusting the seat. Unsupervised or careless seat adjustment could cause parts of the body to get pinched, which increases the risk of injury.
  • Always pull forward on the backrest to make sure it is correctly locked in place.

Adjusting the seats

Sitting correctly and safely
Fig. 52 Adjusting the position

Sitting correctly and safely
Fig. 53 Adjusting the backrests

Adjusting the seat position

  • To adjust the seat forward or back, pull the handle fig. 52 and slide the seat.
  • Release the handle and continue sliding the seat until it locks into place.

Adjusting the backrests

  • Support the backrest with one hand and pull the strap 1 at the same time.
  • Move the backrest forward or back to the desired position.
  • Release the strap and continue moving the backrest until it locks into place.

READ NEXT:

  Steering wheel

General information Make sure that: The distance between your upper body and the steering wheel is at least 10 inches (25 cm). Your arms are bent slightly at the elbows. You have a sufficient vie

  Head restraints

General information Applies to: vehicles with adjustable head restraints Fig. 55 Correctly-adjusted head restraint Make sure that: The upper edge of the head restraint is as even as possible with

  Safety belts

General information Each seat is equipped with a three-point safety belt. Safety belts that are worn correctly are the most effective way to reduce the risk of serious or fatal injuries in a collision

SEE MORE:

  Using adaptive cruise assist

Applies to: vehicles with adaptive cruise assist Fig. 99 Lever: using adaptive cruise assist Fig. 100 Operating lever: changing the speed Switching on To switch on the adaptive cruise assist, pull the lever up to position 1 until it engages. Storing the speed and activating regulation If you

  Attachments, Removing and Installing

Bumper Cover Side Mount, Removing and Installing Removing - Remove the rear bumper cover. Refer to → Chapter "Bumper Cover, Removing and Installing". - Remove the bolts -arrows-. - Remove the bumper cover mount -1-. Installing Install in reverse order of removal. Note t

© 2019-2026 Copyright www.auq3.net | 0.0109