Audi Q3: Navigation System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Navigation System
- Overview - Navigation System
- Chip Card Reader Control Module, Removing and Installing
- Connector Assignments, Ready4Nav 7Q4, Navigation Packet 7T2
READ NEXT:
Overview - Navigation System
Overview - Navigation System, General Information
The navigation system is available on vehicles with
Ready4Nav (7Q4), Navigation packet (7T2) and MMI navigation plus
(7T6).
The navigation s
Chip Card Reader Control Module, Removing and Installing
The Chip Card Reader Control Module -J676--1-
is located inside the glove compartment
-2-.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
-&nb
Connector Assignments, Ready4Nav 7Q4, Navigation Packet 7T2
Information Electronics Control Module 1 -J794-
1 - Connector AM/FM1 from the Antenna Amplifier -R24- (Radio
Antenna 2 -R93-)
2 - DAB connection from Antenna Amplifier 4 -R113-SEE MORE:
Instrument Cluster
Overview - Instrument Cluster
1 - Outside Air Temperature Sensor -G17-
Removing and installing. Refer to
→ Chapter "Outside Air Temperature Sensor, Removing and Installing".
2 - Connector
For Outside Air Temperature Sensor -G17-
3 - Windshield
Overview - Headlamp
Overview - Headlamp, Headlamp Mount
1 - Ventilation Hose
For the headlamp housing
2 - Lover Mount
For the headlamp housing
Removing and installing. Refer to
→ Chapter "Lower Headlamp Housing Mount, Removing and Installing".
3 - Seal
4 -
© 2019-2026 Copyright www.auq3.net | 0.0119
