Audi Q3: Infotainment System
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Infotainment System
- Overview - Infotainment System
- Infotainment System Display, Removing and Installing
- Connector Assignments, MMI Navigation Plus
READ NEXT:
Overview - Infotainment System
MMI Navigation Plus, 7T6
Information Electronics Control Module 1 -J794- with DVD
player/SD card reader/navigation system integrated in the
instrument panel
Internal hard drive memory (HDD)
Infotainment System Display, Removing and Installing
Infotainment System Display, Removing and Installing
The Front Information Display Control Head -J685- (Display)
is located in the center of the instrument panel.
The display and display support a
Connector Assignments, MMI Navigation Plus
Information Electronics Control Module 1 -J794-
1 - GSM connection from Roof Antenna -R216-
2 - 4-Pin Connector -T4u- to the External Audio Source
Connection -R199-SEE MORE:
Starting the vehicle
Convenience key
Applies to: vehicles with convenience key
Fig. 79 Center console: starting the engine
Requirement: the key must be in the vehicle.
Starting the engine
Press and hold the brake pedal.
Press the button. The
engine
will start.
Equipment that uses a lot of electricity is switche
Rear Seat Backrest, Removing and Installing
Rear Seat Backrest, Removing and Installing
Note
The following describes removing and installing the right
2/3 section of the backrest. Removing and installing the left
1/3 rear seat backrest is identical.
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
© 2019-2026 Copyright www.auq3.net | 0.0096
