Audi Q3: Digital compass
Switching the compass on and off
Applies to: vehicles with digital compass
.png)
Fig. 48 Rearview mirror: digital compass is switched on
- To turn the compass on or off, press the button 1 until the compass display in the mirror turns on or off.
The digital compass only works when the ignition is turned on. The directions are indicated with abbreviations: N (north), NE (northeast), E (east), SE (southeast), S (south), SW (southwest), W (west), NW (northwest).
Tips
To prevent inaccurate compass readings, do not bring any remote controls, electrical devices or metallic objects near the mirror.
Adjusting the magnetic zone
Applies to: vehicles with digital compass
The magnetic zone must be adjusted correctly for the compass to read accurately.
.png)
Fig. 49 Magnetic zone map
- Press and hold the button 1
.png)
fig. 48
until the number of the magnetic zone appears
in the interior rearview mirror. - Press the button 1 repeatedly to select the correct magnetic zone. The selection mode turns off after a few seconds.
Calibrating the compass
Applies to: vehicles with digital compass
You must recalibrate the compass if it does not display the correct direction.
- Press and hold the button 1 until a C
.png)
fig. 48 appears in the rearview
mirror. - Drive in a circle at about 6 mph (10 km/h) until a direction is displayed in the rearview mirror.
WARNING
To reduce the risk to yourself and other drivers, calibrate the compass in an area where there is no traffic.
READ NEXT:
Correct passenger seating position
General information
As the driver, you are responsible for making sure
every passenger is sitting correctly in their seat
and maintaining this seating position while driving.
Make sure that:
Every
Front seats
General information
Make sure that:
You can press the pedals down completely
while your legs are slightly bent.
The distance between your upper body and the
steering wheel or instrument panel is SEE MORE:
Wheels and Tires, General Information
Only install tires with the same manufacturer, construction
type and tread on all wheels.
Always replace rubber valve when replacing steel wheel or
rim.
Install tires with DOT identification facing toward outside
of wheel. Only applies to left side of vehicle with directional
tires.
With
Rear Window Wiper System
Overview - Rear Window Washer System
1 - Water Hose
For the rear window washer system
2 - Nut
8 Nm
3 - Rear Window Wiper Motor -V12-
Removing and installing. Refer to
→ Chapter "Rear Window Wiper Motor -V12-, Removing and Installing".
4&