Audi Q3: General, Technical data
Audi Q3 (8U) 2011-2018 Service Manual / Heating, Ventilation & Air Conditioning / General, Technical data
READ NEXT:
Type Label
The type label for refrigerant and filling capacities is
located on the lock carrier cover.
1 - Refrigerant identification, such as R134a
2 - Refrigerant capacity
3 -&nbs
Seat Heating
Vehicles with Manual Climate Control System (Heater without A/C System)
Components which participate in the activation of the seat
heating
The A/C Control Module -J301- (the Heater Control Module
SEE MORE:
0.22 mm 2 Wire, Repairing with Individual
Crimp Connector
Procedure
- Free up the wire to be repaired approximately 20 cm on both
sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harnesses carefully.
- If necessary, removing the wiring harness wrapping using a
knife.
- Cut ou
Tie Rod, Removing and Installing
Tie Rod, Removing and Installing, FWD Vehicles
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Removing
- Measure dimension from center of wheel to lower edge of
wheel housing. Refer to
→ Chapter "Wh
© 2019-2024 Copyright www.auq3.net
