Audi Q3: General information
- Park the vehicle as far as possible from moving
traffic in the event of a breakdown. In the event
of a flat tire, park the vehicle on a level surface.
If you are on a steep hill, be especially careful.
- Set the parking brake.
- Switch the emergency flashers on.
- Have the passengers exit the vehicle. They should move to a safe place, for example behind a guard rail.
WARNING
Follow the steps given above. This is for your protection and the for the safety of others on the road.
Equipment
Vehicle tool kit/vehicle jack
Applies to: vehicles with the vehicle tool kit and vehicle jack
.png)
Fig. 158 Luggage compartment: cargo area floor
The vehicle tools and vehicle jack are stored in the luggage compartment under the cargo floor.
- Lift up the cargo floor with the plastic handle until it is clamped behind the tabs on both side panels.
- If necessary, lift out the center floor panel
Applies to: vehicles with spare tire/subwoofer
- Turn the handwheel counter-clockwise and remove it.
- Remove the subwoofer.
- Remove the spare tire.
Tips
The vehicle jack does not require any maintenance.
READ NEXT:
Changing a tire
Preparation
You must complete the preparation before
changing a tire.
Read and follow the important safety precautions.
Set the parking brake.
Select the "P" position.
When towing a trailer: disc
Spare tire
Removing the subwoofer
Applies to: vehicles with subwoofer
The subwoofer must be removed before the
spare tire/temporary spare tire can be removed.
Fig. 166 Spare tire well: subwoofer
Removing the su
Jump starting
Preparation
You should only perform the steps that follow if
you have the necessary tools and technical expertise.
If the engine does not start because the vehicle
battery is drained, you can jump sta
SEE MORE:
Vehicle Alignment
Axle Alignment Information
Wheel alignment must only performed using VW/Audi-approved
wheel alignment equipment.
Each time wheels are aligned, both front and rear wheels
must be aligned.
Otherwise, proper vehicle drivability cannot be ensured.
Otherwise centering of toothed shaft cannot be g
Vehicle Pulls to One Side
General Information
Perform a road test to determine if a vehicle pulls to one
side and if so, when and to which side. If the vehicle pulls to
one side, see procedure
→ Chapter "Corrective Action when Vehicle Pulls to One Side".
If the vehicle alignment is measured, submit the measure
© 2019-2026 Copyright www.auq3.net
