Audi Q3: Front Heater and A/C Unit
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Front Heater and A/C Unit
- Overview - Heater and A/C Unit Attachments and Air Intake Housing
- Evaporator, Removing and Installing
- Auxiliary Heater Heating Element -Z35-, Checking
- Heater and A/C Unit, Removing and Installing
- Air Distribution Housing, Removing and Installing
- Heater Core, Removing and Installing
- Condensation Water Drain, Checking
READ NEXT:
Overview - Heater and A/C Unit Attachments and Air Intake Housing
Overview - Heater and A/C Unit Attachments and Air Intake Housing
1 - Sealing Plug
Equipment version
2 - Screw
1.5 Nm
3 - Screw
1.5 Nm
4
Evaporator, Removing and Installing
Removing
- Removing the air distribution housing. Refer to
→ Chapter "Air Distribution Housing, Removing and Installing".
- Remove the spacer foam -6-.
- Remove the bolts -1
Auxiliary Heater Heating Element -Z35-, Checking
Note
An auxiliary heater is currently installed in vehicles with
a TDI engine. After leaving the heater core for the heater/A/C
unit, the air is supplied with heat energy on this systSEE MORE:
Power sources
When the ignition is switched on, you may be
able to use multiple power sources for external
devices, depending on the vehicle equipment.
12 volt sockets
You can connect electrical accessories to the 12
volt sockets. The power usage from the sockets
must not exceed a total of 120 watts. Do not
conne
Switching lane guidance on and off
Applies to: vehicles with adaptive cruise assist and lane guidance
Fig. 101 Turn signal lever: button for lane guidance and
lane departure warning
Within the limits of the system, lane guidance
provides corrective steering to assist the driver
with keeping the vehicle in the center of the lane
as m
© 2019-2026 Copyright www.auq3.net | 0.0106
