Audi Q3: Antenna Systems
Electrical System / Audi Q3 (8U) 2011-2018 Service Manual / Antenna Systems
- Overview - Antenna Systems
- Antenna Amplifier, Removing and Installing
- Roof Antenna, Removing and Installing
- Antenna Amplifier Connector Assignments
READ NEXT:
Overview - Antenna Systems
The antenna system consists of the Roof Antenna -R216- and
the window antenna.
Roof Antenna -R216-
GPS Antenna -R50-, only on 7T2, 7T6 and 7Q4
Telephone Antenna -R65-, only on 9ZF and 9ZW
S
Antenna Amplifier, Removing and Installing
Antenna Amplifier -R24-, Removing and Installing
The Antenna Amplifier -R24- is located on the upper left of
the rear lid.
Removing
- Turn off the ignition and all electrical equipment and
Roof Antenna, Removing and Installing
The Roof Antenna -R216- has up to three connectors.
The antenna wires are connected directly to the base of the
Roof Antenna -R216-.
The headliner must be lowered in order to remove the Roof
AntSEE MORE:
RSQ3 Spoiler-Lower Section, Removing and Installing
Removing
- Remove the lower radiator grille. Refer to
→ Chapter "Radiator Grille, Removing and Installing, Audi RS Q3
through MY 2014".
- Remove the bolt -arrow-.
- Release the catches -1- and
remove the spoiler lower section -3-
forward from the bumper cover -2-.
LED Headlamp, Adjusting
Checking and adjusting conditions
Tire pressure is OK.
The headlamp glass must be clean and dry.
The headlamp glass must not be damaged.
Headlamp reflectors and bulbs are OK.
The vehicle must be under load.
Vehicle load on driver seat in otherwise unloaded vehicle
(curb weight).
© 2019-2026 Copyright www.auq3.net | 0.0138
