Audi Q3: A/C Compressor
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / A/C Compressor
- Overview - A/C Compressor Power Unit
- Overview - Belt Pulley
- Overview - Belt Pulley, Valeo A/C Compressor
- A/C Compressor, Removing and Installing on Bracket
- Refrigerant Lines, Disconnecting and Connecting at A/C Compressor
- Belt Pulley, Removing and Installing
- Belt Pulley, Removing and Installing, Valeo A/C Compressor
READ NEXT:
Overview - A/C Compressor Power Unit
Overview - A/C Compressor Power Unit, 4-Cylinder Engine
1 - Ribbed Belt
Check for wear
Removing and installing. Refer to
→ Rep. Gr.13; Cylinder Block, Belt Pulley Side
Overview - Belt Pulley
Overview - Belt Pulley, Denso A/C Compressor, Version 1
Note
This type of belt pulley is installed on a "7 SEU 16" A/C
compressor.
1 - Bolt
20 Nm
Replacing
2&nb
Overview - Belt Pulley, Valeo A/C Compressor
1 - Bolt
17 Nm
Replacing
- The threaded bolt holes, into which the self-locking bolts or bolts
with locking compound were installed, must be cleaned (for example with SEE MORE:
Subframe, Securing
Special tools and workshop equipment
required
Locating Pins -T10096-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Procedure
- Remove the noise insulation -1-.
Refer to
→ Body Exterior; Rep. Gr.66; Noise Insulation; Noise Insulation,
Ribbed Belt Pulley without Freewheel, Removing and Installing
Special tools and workshop equipment
required
Generator Belt Socket -3310-
Inner hex socket 8 mm or TORX
T50
Removing
- Remove the generator if necessary. Refer to
→ Electrical Equipment; Rep. Gr.27; Generator; Generator,
Removing and Installing.
- For so
© 2019-2026 Copyright www.auq3.net | 0.0169
