Audi Q3: Suspension
Adaptive dampers
Applies to: vehicles with suspension control
The adaptive dampers are an electronically-controlled damping system. The firmness of the suspension will adapt to the driving conditions and the driving situation. The settings depend on the selected Audi drive select mode.
Ground clearance
The vehicle height and clearance can be influenced by the following factors:
- Change in temperature
- Change in load
WARNING
To reduce the risk of injury, make sure no one gets pinched when the vehicle level is changing, for example when cleaning the underbody or the wheel housings.
Note
Always make sure there is enough clearance above and below the vehicle. This is especially important for entrances with height restrictions, for example, before driving into underground garages. You could also scrape the ground when driving over the edges of curbs or on steep ramps, which could damage your vehicle.
Messages
The following messages may appear depending on the vehicle equipment:
.png)
Suspension: malfunction! You
can continue
driving
There is a malfunction. See an authorized Audi dealer or authorized Audi Service Facility for assistance.
READ NEXT:
Steering
Description
Electromechanical steering supports the driver's
steering movements by electronically adapting
the power steering depending on the vehicle
speed. The settings depend on the selected Audi
d
All wheel drive (quattro)
Description
Applies to: vehicles with all wheel drive
The all-wheel drive system distributes the driving
power variably to the front and rear axle to improve
the driving characteristics. It works tog
Electronic Stabilization Control
Description
Electronic Stabilization Control (ESC) supports
driver safety. It reduces the risk of slipping and
improves driving stability. ESC detects critical situations,
such as if the vehicle is ov
SEE MORE:
Chip Card Reader Control Module, Removing and Installing
The Chip Card Reader Control Module -J676--1-
is located inside the glove compartment
-2-.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
- Remove the glove compartment. Refer to
→ Body Interior; Rep. Gr.68; Storage Co
Wheel, Changing and Mounting
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Wheel Lock Set -T10101-
Wheel Lock Set -T10101A-
Wheel Lock Set -T40004-
Wheel Lock Set -T40073-
Wax Spray -D 322 000 A2-
Optimol TA Paste -G 052 109 A2-
Note
The wrench size of the inc
