Audi Q3: Radio
READ NEXT:
Overview - Radio Components
Overview - Radio, Radio Chorus, CAN, 8UA
Radio with integrated CD player
Sound system: basic, 8RE
Optional
Sound system: basic plus, 8RX
Cell Phone Preparation Preliminary Setup
The
Radio, Removing and Installing
Radio, Removing and Installing, Radio Chorus, 8UA
The Radio -R- is located in the instrument panel.
Note
If replacing the control module, select the "Replace control
module" function for
Connector Assignments, Radio Chorus, 8UA
Radio -R-
1 - Connector AM/FM1 from the Antenna Amplifier -R24- (Radio
Antenna 2 -R93-)
2 - Connection block with four multi-pin connectors
Note
Unlist
SEE MORE:
Drive Axle, Removing and Installing, Drive Axle with Triple Roller Joint
AAR3300i, Mounted on Transmission Stub Shaft
Special tools and workshop equipment
required
Slide Hammer Set -VW771-
Tensioning Strap -T10038-
Puller - Driveshaft -T10382-
Torque Wrench 1332 40-200Nm -VAG1332-
Digital Torque Wrench -VAG1756A-
Removing
- Loosen the drive axle threaded connection on the wheel side.
Refer
Steering Column Switch Module, Removing and Installing
Steering Column Switch Module, Removing and Installing, with Mechanical
Ignition Lock
Removing
- Adjust steering wheel downward and to rear as far as
possible, use entire adjustment range of steering column
adjustment for this.
- Remove the driver airbag. Refer to
→ Body
© 2019-2026 Copyright www.auq3.net
