Audi Q3: Pressures, Checking
Heating, Ventilation & Air Conditioning / Audi Q3 (8U) 2011-2018 Service Manual / Pressures, Checking
- General Information
- Refrigerant Circuit, Checking Pressure with Service Station
- Checking Pressures for Vehicles with Restrictor and Reservoir (with Internally Regulated Compressor)
- Checking Pressures on Vehicles with Expansion Valve and Receiver/Dryer (with Internally Regulated Compressor)
- Vehicles with Restrictor, Reservoir and A/C Compressor Regulator Valve -N280- (Externally Regulated A/C Compressor), Checking Pressures
- Vehicles with Restrictor, Receiver/Dryer and A/C Compressor Regulator Valve -N280-, Checking Pressures, Externally Regulated Compressor
- Checking Pressures on Vehicles with Electrically Driven A/C Compressor (Vehicles with Hybrid Drive)
- Refrigerant Circuit Pressures Specified Values, Vehicles with Heat Pump
READ NEXT:
General Information
Vehicles with a High Voltage System (Hybrid Vehicles)
Extremely Dangerous Due to High-Voltage
The high-voltage system is under high-voltage. Death or serious
bodily injury by electric shock.
-&nb
Refrigerant Circuit, Checking Pressure with Service Station
General Information
Note
All test conditions marked are vehicle-specific and are
described in the Repair Manual for the relevant vehicle.
Check cooling performance.
Connections wit
Checking Pressures for Vehicles with Restrictor and Reservoir (with
Internally Regulated Compressor)
General Information
Note
Connect the A/C service station. Refer to
→ Chapter "A/C Service Station, Connecting".
Observe the test requirements. Refer to
→ Chapter "PresSEE MORE:
Status display
Fig. 15 Center display: frequently used symbols in the status
bar
The symbols in the status bar show you information at a glance, such as if a
mobile device is connected or if there is a data connection. The most
common symbols are listed in the table.
There is a data connection. The bar indicat
CV Joint, Servicing, Drive Axle with Triple Roller Joint AAR3300i, Mounted
on Transmission Stub Shaft
Special tools and workshop equipment
required
Tripod Joint Tool -T10065-
Puller - Driveshaft -T10382-
Hose Clip Pliers -VAG1275A-
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Clamping Pliers -VAG1682A-
Press Plate -VW401-
Press Plate -VW402-
Press P
© 2019-2026 Copyright www.auq3.net | 0.0136
