Audi Q3: Opening and closing the luggage
compartment lid
.png)
Fig. 28 Rear lid: handle
.png)
Fig. 29 Driver's door: opening the luggage compartment lid
Opening the luggage compartment lid
- Applies to: vehicles without convenience key:
Unlock the vehicle or the luggage compartment
lid using the
button on the
vehicle key
and press the handle in the luggage compartment
lid
fig. 28. Or
- Applies to: vehicles with convenience key: Press
the handle in the luggage compartment lid
fig. 28. When the luggage
compartment is
locked, the vehicle key cannot be more than approximately
4 feet (1.5 m) away from the luggage
compartment. Or
- Applies to: vehicles with automatic luggage
compartment lid: Select the "P" selector lever
position and pull the
button in
the driver's
door.
Closing the luggage compartment lid
- Applies to: vehicles without automatic luggage
compartment lid: Use the inside handle to pull
the luggage compartment lid down and allow it
to drop gently to close it. Or
- Applies to: vehicles with automatic luggage compartment lid: Note
WARNING
Observe the safety precautions.
READ NEXT:
Applies to: vehicles with automatic luggage compartment
Fig. 30 Luggage compartment lid: 1 closing button, 2
lock button (vehicles with convenience key)
The luggage compartment lid can be opened and
Applies to: vehicles with sensor-controlled luggage compartment
lid
Fig. 31 Vehicle rear: foot motion (example)
The luggage compartment lid can be opened and
closed automatically 1).
Requirements: yo
The child safety lock prevents the rear doors
from being opened from the inside and the rear
power windows from being operated.
Fig. 33 Drive's door: controls
Fig. 34 Rear door: manual child safety
SEE MORE:
Fig. 152 Engine compartment with battery: connections
for charger and jump start cable
Observe the safety precautions.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The battery is located in the engine compartment.
The ground po
Special tools and workshop equipment
required
Wedge Set -T10383-
Removing
- Switch the ignition off and remove the ignition key.
- Remove the trim panel. Refer to
→ Chapter "Trim Molding, Removing and Installing".
- Remove the pull handle grip recess. Refer to
â†