Audi Q3: Memory function
General information
With the memory function, you can save and call
up seat profiles using the memory buttons in the
door trim panel.
Depending on vehicle equipment, some settings
such as the driver's seat and exterior mirror position
can be stored.
Storing and recalling a seat profile
The memory function buttons are located in the
door trim panel.
Storing a seat profile
- Press the [SET] button. If the LED in the button
turns on, a seat profile can be stored.
- Push one of the numbered memory buttons. A
tone confirms that the settings were stored.
Recalling a seat profile
- When the a door is open and the ignition is
switched off, press the memory button once
briefly. The seat will be fully adjusted to the
settings in the seat profile.
- If the door is closed or the ignition is switched
on, press and hold the memory button until the
seat is fully adjusted to the settings in the seat
profile.
WARNING
- To reduce the risk of an accident, the seat
setting can only be recalled when the vehicle
is stationary.
- In an emergency, the recall process can be
canceled by pressing the seat adjustment
button on that seat.
READ NEXT:
General information
WARNING
If you have not fastened your safety belt,
you are in an incorrect seating position, or
you are too close to the airbag system, the
airbag system will not be able to p
The
indicator light in the instrument cluster
monitors the safety systems such as the airbags
(including the control modules, sensor, and wiring)
and the belt tensioners. It turns on when you
switch
Fig. 64 Headliner: indicator light to display the
status of the front passenger's airbag
The Advanced Airbag System in your vehicle has
been certified to comply with the requirements
of the United S
SEE MORE:
General information
Make sure that:
The distance between your upper body and the
steering wheel is at least 10 inches (25 cm).
Your arms are bent slightly at the elbows.
You have a sufficient view of the area around
the vehicle and you have a clear view of the instrument
cluster
You are alwa
Center Tunnel Heat Shield, Removing and Installing
Removing
- Remove the left and right underbody cover. Refer to
→ Chapter "Underbody Panels, Removing and Installing".
- Remove the driveshaft heat shield. Refer to
→ Chapter "Driveshaft Heat Shield, Removing and Installi