Audi Q3: Lower Rear Lid Trim Panel, Removing and Installing
Lower Rear Lid Trim Panel, Removing and Installing
Special tools and workshop equipment required
- Pry Lever -80-200-
- Omega Clip Tool -T40280-
Removing
- If installed, remove the rear shelf. Refer to → Chapter "Rear Shelf Rear Section, Removing and Installing".
- Remove the tail lamp cover. Refer to → Chapter "Tail Lamp Cover, Removing and Installing".
- Open the emergency triangle cover and remove the emergency triangle. Refer to → Chapter "Emergency Triangle Cover, Removing and Installing".
- Remove the expanding clips -1-.
- Unclip the rear lid lower trim panel -2- clamps all the way around using the Pry Lever -80 - 200--arrows-.
- Equipment level: disconnect the Rear Lid Closing Button -E574- connector.
- Remove the lower rear lid trim panel.
Installing
Install in reverse order of removal.
Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Lower Rear Lid Trim Panel".
Emergency Release Cover, Removing and Installing
Special tools and workshop equipment required
- Trim Removal Wedge -3409-
Removing
- Place the Trim Removal Wedge -3409- on the opening and unclip the emergency release cover -1- from the lower rear lid trim panel.
Installing
Install in reverse order of removal.
Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Lower Rear Lid Trim Panel".
Upper Rear Lid Trim Panel, Removing and Installing
Special tools and workshop equipment required
- Pry Lever -80-200-
- Omega Clip Tool -T40280-
Removing
- Remove the lower rear lid trim panel. Refer to → Chapter "Lower Rear Lid Trim Panel, Removing and Installing".
- Remove the expanding clip -1-.
- First unclip the rear lid upper trim panel -2- from the sides of the rear lid -A arrows- using the Pry Lever -80 - 200-.
- Then unclip the rear lid upper trim panel using the Pry Lever -80 - 200- from the rear lid -B arrows- and remove.
Installing
Install in reverse order of removal.
Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Lower Rear Lid Trim Panel".
READ NEXT:
Luggage Compartment Side Trim Panel, Removing and Installing
Special tools and workshop equipment
required
Pry Lever -80-200-
Omega Clip Tool -T40280-
Removing
- If installed, remove the luggage compartment roller cover.
- Remove the rear
Rear Luggage Compartment Floor Handle, Removing and Installing
Special tools and workshop equipment
required
Pry Lever -80-200-
Removing
- Remove the luggage compartment floor panel.
- Release the mounting bracket -1-
from the underside of
Roof Trim Panels
Component Location Overview - Roof Trim Panel
1 - Roof Grab Handle
Overview. Refer to
→ Chapter "Overview - Sun Visors".
2 - Sun Visor
Overview. Refer to
âSEE MORE:
Personalization
General information
Applies to : vehicles with personalized user settings
Depending on vehicle equipment and your country,
your vehicle may be able to manage various
users in the MMI. Each user will be assigned the
settings that they last used.
Before you begin driving, you can select a user in
th
Parking Brake
Overview - Parking Brake
1 - Bolt
Tightening specification, refer to item-14-.
2 - Parking Brake Motor
Left Parking Brake Motor -V282-, Right Parking Brake Motor -V283-
Removing and installing, refer to
→ Chapter "Left/Right Parking Brake Motor -V282-/-V2