Audi Q3 Owners & Service Manuals

Audi Q3: Dimming the mirrors

Manual dimming rearview mirror

  • Pull the lever on the bottom of the mirror back.

Automatic dimming rearview mirror

  • The interior and exterior mirrors dim automatically when light shines on them, for example from headlights on a vehicle behind you.

WARNING

Applies to: vehicles with automatic dimming mirrors

  • If the glass on an automatic dimming mirror breaks, electrolyte can leak out. This liquid can irritate the skin, eyes and respiratory system. If there is contact with the fluid, flush immediately with plenty of water. Consult a physician if necessary.
  • Repeated or long-term exposure to electrolyte fluid can lead to irritation of the airways, especially in people with asthma or other respiratory conditions. Take deep breaths immediately after leaving the vehicle or, if this is not possible, open all of the doors and windows as wide as possible.
  • If electrolyte fluid comes into contact with the eyes, flush them thoroughly with plenty of clean water for at least 15 minutes and then seek medical attention.
  • If electrolyte fluid comes into contact with the skin, flush the affected area with clean water for at least 15 minutes, and then clean with soap and water and seek medical attention. Clean affected clothing and shoes thoroughly before wearing again.
  • If the fluid was swallowed and the person is conscious, flush the mouth with water for at least 15 minutes. Do not induce vomiting unless this is recommended by medical professionals.

    Seek medical attention immediately.

Note

Applies to: vehicles with automatic dimming mirrors

If the glass on an automatic dimming mirror breaks, electrolyte can leak out. This liquid damages plastic surfaces and paint. Clean this liquid as quickly as possible, for example with a wet sponge.

Tips

Applies to: vehicles with automatic dimming mirrors

  • If the light reaching the rearview mirror is obstructed, the automatic dimming mirror.

    will not function correctly,

  • The automatic dimming mirrors do not dim when the interior lighting is turned on or the reverse gear is selected.

Sun visors

Lights and Vision
Fig. 43 Front headliner: sun visor

Sun visor

The sun visors can be moved out of their brackets and turned toward the doors 1.

They can also be moved back and forth lengthwise in this position.

Vanity mirror

The mirror light switches on when the cover over the vanity mirror 2 opens.

    READ NEXT:

     Windshield wipers

    Switching the windshield wipers on Fig. 44 Lever: windshield wipers Fig. 45 Lever: rear window wiper Move the lever to the corresponding position: 0 - Windshield wipers off 1 - Rain sensor/intermi

     Cleaning/changing wiper blades

    Fig. 46 Windshield wipers: changing the wiper blades Wiper blade replacement position Switch off the ignition and hold the windshield wiper lever in position 4 fig. 44 until the windshield wip

     Cleaning/changing the rear wiper blade

    Fig. 47 Rear window wiper: installing the wiper blade Cleaning the wiper blades Fold the wiper arm away from the rear window. For information on cleaning. Removing the wiper blade Fold the wipe

    SEE MORE:

     High Pressure Sensor -G65-, Removing and Installing

      Note When the High Pressure Sensor -G65- is removed, the cooling output cannot be checked. The Climatronic Control Module -J255-/A/C Control Module -J301- control head does not switch on the Air Conditioning (A/C) compressor. Refer to Vehicle Diagnostic Tester in the "Guided Fau

     Floor Heat Shield, Removing and Installing

    Center Tunnel Heat Shield, Removing and Installing Removing - Remove the left and right underbody cover. Refer to → Chapter "Underbody Panels, Removing and Installing". - Remove the driveshaft heat shield. Refer to → Chapter "Driveshaft Heat Shield, Removing and Installi

    © 2019-2025 Copyright www.auq3.net